JVC HR-S7900U manual Edit To Or From Another, 48 EN, Connection

48 EN EDITING (cont.)

Edit To Or

From Another

VCR

2 Load cassettes

Insert the playback cassette into the playback VCR and the cassette to be recorded on into the recording VCR.

3 Select input mode on recording VCR Select the correct external input on the other VCR.

Connection
Ex. When using this VCR as the playback VCR
This VCR (for playback)
		REMOTE
		PAUSE/ IN OUT ANTENNA IN
	CABLE	AV
		COMPU
	BOX	-LINK
S IN	OUT	AUDIO
		VHF/UHF
V		TV OUT
I		VIDEO
D
E
O
To S VIDEO		To AUDIO/
OUT		VIDEO OUT
S-video cable			4
(supplied)		Audio/video
		cable (supplied)
To S-video		To Audio/
Input		video Input
Another VCR (for recording)			5

●On this VCR (when using this VCR as the recording VCR);

Select “L-1” — when connecting the other VCR to the audio/video input connectors on the rear panel;

Select “F-1” — when connecting the other VCR to the audio/video input connectors on the front panel.

On the front panel:

Push the JOG dial, then turn it to the left or right.

On the Remote:

Press the Number key "0 (AUX)" and/or CH +/–.

Select video input terminal on recording

VCR

When using this VCR as the recording VCR, follow the procedure described on pages 39 and 43.

When using S VIDEO terminal, set “FRONT AUX INPUT” (or “REAR AUX INPUT” if you use the connectors on the rear) to “S-VIDEO”.

When using VIDEO terminal, set “FRONT AUX INPUT” (or “REAR AUX INPUT”) to “VIDEO”.

Select edit mode

On this VCR, set “PICTURE CONTROL” to “EDIT” by following the procedure described on pages 39 and 40.

You can use your VCR as the playback or recording VCR.

●Refer also to the other VCR’s instruction manual for connection and its operations.

1Make connections

Connect an audio/video cable between the playback VCR’s audio/video output connectors and the recording VCR’s audio/video input connectors.

●When using this VCR as the recording VCR, connect this VCR’s audio/video input connectors to the audio/video output connectors on the other VCR.

If the playback VCR is monaural, connect the audio output connector on the playback VCR to the left audio input connector on this VCR.

6 Start playback

Press PLAY ( 3 ) on the playback VCR.

NOTE:

If the playback VCR is equipped with a superimpose/ OSD disable feature then set it to “OFF” before starting playback (☞ pg. 39 and 40).

7Start recording

Press REC ( ¦ ) on the recording VCR.

NOTE:

Be sure to select “AUTO” for “PICTURE CONTROL” (or “NORM” when “VIDEO CALIBRATION” is set to “OFF”) after you finish dubbing the tapes (☞ pg. 39 and 40).