26ADVANCEDOPERATIONS (cont.)
Automatic Satellite Programme Recording
This facility allows you to record automatically a satellite programme which is
Outdoor Unit
Satellite Cable
Satellite Receiver Unit
DECODER | VCR | TV |
Aerial | Aerial connector | |
Back of TV | ||
|
TV Aerial cable
ANT. IN
EXT.2EXT.1
RF OUT
Mains outlet
AV1 OUT switch
S OUT | AV1 OUT | ||
|
|
|
|
COMP. Y/C
AV1 IN/OUT |
AV2 IN
ANT. IN
R L
AUDIO OUT
RF OUT
PAUSE
Back of Recorder
IMPORTANT
Set "AV2 SELECT" to "SAT" on the Mode Set screen in step 3 of page 27. If you set "AV2 SELECT" to "SAT"...
● It is possible to view a satellite programme with the TV set to its AV mode even if the recorder's power is turned off as long as the recorder is not in the Timer mode.
● The AV2 IN connector's input is the same signal that is controlled by the rear panel AV1 OUT switch as shown below:
a- If both the satellite receiver and the TV are compatible with the Y/C signal, set the AV1 OUT switch to Y/C in order to take advantage of
b- If the satellite receiver and/or the TV are/is not compatible with the Y/C signal, set the AV1 OUT switch to COMP.
AV2 SELECT setting on | Rear panel AV1 OUT | AV2 IN connector input | * The composite signal is a regular video | |
the MODE SET screen | switch | signal | signal. | |
|
|
| ** The Y/C signal is a signal in which the | |
| COMP. | Composite signal* | ||
SAT | luminance and chrominance signals are | |||
|
| |||
Y/C | Y/C signal** | separated. | ||
| ||||
|
|
|
|
NOTE:
Refer to the instructions supplied with your satellite receiver.