advanced features
Video Channel Set
47
before you start
The power cord must be plugged in and connected to the VCR
The VCR must be turned off and no cassette inserted
The Remote Control must have the battery inserted
The TV set must be turned on
The VCR can send picture signals to the TV set in one of two ways; RF (ordinary cable included with this VCR) and AV (via a
Access Video Channel Mode
Press and hold the Sbutton for 5 seconds on the VCR until the display panel shows the following information:
Set Video Channel
for av connection Press PR 
button until the display panel shows:
The Video Channel is now set to OFF. Go to Step 3.
for rf connection Press PR 
or PR 
button to set the VCR to a vacant channel number between 52 and 69 which is not occu- pied by any station in your area (refer to station
list on page 53). In the example, we have presumed that channel 52 is vacant and have set the VCR to 52:
Now tune the TV set to channel 52 (refer to TV manual if necessary); you should see two vertical white bars appear on the TV screen. If the bars do not appear or are not clear, choose another vacant channel and try again. If you cannot obtain the vertical white bars on any channel between 52 and 69, consult your local JVC dealer.
Exit Video Channel Set Mode
Press OK button .
To view pictures from your VCR you must now set your TV to either the Video
Channel or to AV mode, depending upon your choice above.
47 | 3/8/04, 10:20 AM |
Black