JVC HR-E939EG Regular Timer Programming, Access Programme Screen, Enter Programme Start Time

26ENTIMERRECORDING(cont.)

Regular Timer Programming

If you don’t know the SowView number for the programme you wish to record, use the following procedure to set your recorder to timer-record the programme.

Or you can use the Illumi-Guide feature, where the remote control tells you which button to press next by lighting it up. To use the Illumi-Guide feature, press ILLUMI GUIDE before performing step 1. (PROG., REW, PLAY, FF light up at this time.)

If you aren't going to use the Illumi-Guide feature, go directly to step 1.

Remember, the clock must be set before you can programme the timer (☞ pg. 7).

Before performing the following steps:	1
● Insert a cassette with the safety tab in place. The recorder
will come on automatically.
● Turn on the TV and select the VIDEO channel (or AV mode).

					8
•• • • • ••		•• • •	• •	•	2
• •	• •	• •	• •

ACCESS TIMER PROGRAM- MING SCREEN

Press PROG.

●If you are using the Illumi-Guide feature, the following buttons will light up: NUMBER keys (0–9),START +/–,STOP +/–,DATE +/–,TV PROG. +/–, and CANCEL.

ACCESS PROGRAMME SCREEN

Press START +/–. (If you’re		– P1 –
just starting out, “P1”	START	STOP
appears.)
	– : – –	= – : – –
	SP		ON
	DATE	TV PROG
	25. 12		– –
	[+/–] =

2

1 2

4 5

7 8

3

6

9

The front display panel looks like this:

SP

CANCEL

START+/–

0

TV PROG.+/–

●If you are using the Illumi-Guide feature, the following buttons will light up: START +/–, STOP +/–, DATE +/–, and TV PROG. +/–.

–

STOP+/

DATE+/ –

ENTER PROGRAMME START TIME

PROG.	3
	1

3

Press START +/– to enter the time you want recording to start.

● Press and hold START

+/– to move in 30-

minute increments, or

press and release

repeatedly to move 1

	– P1 –
START	STOP
21 : 00	= – : – –
SP		ON
DATE	TV PROG
25. 12		– –
[+/–] =

ILLUMI GUIDE

When Using The Illumi-Guide Feature

●Buttons light or blink on the remote control for approximately 10 seconds. If the button or buttons extinguish during timer programming, press ILLUMI GUIDE and the button or buttons previously lit or blinking come back on. If the button or buttons do not re-light or start blinking again, press CANCEL and re-perform the timer programming procedure from the beginning.

●If for some reason the remote control's signal is not received by the video recorder, press CANCEL and re-perform the timer programming procedure from the beginning.

minute at a time.

The front display panel looks like this:

SP

●If you are using the Illumi-Guide feature, the following buttons remain lit: START +/–, STOP +/–, DATE +/–, and TV PROG. +/–.