Magnavox MVR430MG, MVR630MG owner manual Helpful Hints cont’d

Page 43

mvr630mg.QX33 2/11/02 12:05 PM Page 43

Helpful Hints (cont’d) 43

You can not insert a tape.

Insert the tape, window side up, with the record tab facing you.

Make sure a tape isn’t already in the VCR by pressing the Stop/Eject C/A button on the VCR.

Gently push on the center of the tape when putting it in the VCR. Never force the tape into the VCR.

If you have programmed a timer recording and the VCR power is off, you can not insert a tape without a record tab.

You can not remove a tape.

Connect the power plug to a power outlet.

You have set a timer recording. Turn on the VCR power, then eject the tape. Be sure to insert a tape and turn off the power for your timer recording.

VCR ejects the tape when you press the REC(ord)/OTR button or when you turn off the VCR power for a timer recording.

Make sure the tape has a record tab. Details are on page 5.

Poor reception

You may need to tune your TV again.

The motor (cylinder) rotates even when the VCR is in Stop mode.

To enable the quick play mechanism, the cylinder will rotate for about five minutes. This is normal. The quick play mechanism allows the tape mechanism to switch from Stop mode to Play mode in one second.

Direct Broadcast System Hookups

Watching one TV channel while recording another may not be possible if you have a DBS hookup. You may have to set your TV to channel 03 or 04, then make your channel selections at the DBS.

If you use audio and video cables to connect your DBS, VCR, and TV, you may have to put your VCR in Line Input mode (channel 001 or 002).

Line Input mode

If you accidentally enter Line Input mode (AV FRONT or AV REAR will appear on your TV screen briefly), press the CH(annel) o/p button or use the Number buttons to select another channel.

Hi-Fi Stereo Sound (MVR630MG only)

During playback, Hi-Fi audio may temporarily revert to normal audio when you adjust tracking. This is normal.

When connecting the VCR to a stereo TV, you will only get stereo sound if you use audio cables to con- nect the AUDIO OUT jacks on the VCR to the AUDIO IN jacks on your TV, and if the TV is in Line (Auxiliary) Input mode. See page 10 for details.

When you connect the AUDIO OUT jacks on the VCR to the AUDIO IN jacks on your TV, the stereo light on the TV might not glow. But, as long as the VCR status display indicates you are receiving a stereo signal, you are receiving a stereo signal. This is normal.

Only tapes recorded in Hi-Fi audio will play in Hi-Fi audio. Tapes recorded in normal audio will play in monaural audio.

Cleaning the Video Heads

Your VCR automatically cleans the video heads each time you insert a tape. However, the heads may become dirty. If so, use a commercially-available head cleaner or have an authorized servicer clean the video heads. Eventually, you may need to replace the heads.

The playback picture is too dim, too bright, or fluctuates in brightness.

Some programs may be broadcast with copyright protection technology in order to protect the rights of copyright owners. This technology is used on programs that are recorded on video tapes or Digital Video Discs (DVDs), as well as some programs broadcast by antenna/cable/satellite television channels. Programs broadcast with copyright protection technology may not record clearly. Likewise, if you play a tape that is a recording of a copyright protected program, the picture may not be clear. Tapes of copy- right protected programs may have a picture that is dark or dim, or the brightness of the picture may fluctuate. Therefore, you should avoid recording or playing copies of copyright protected programs. This VCR incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation and is intended for home and other limited viewing uses only, unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.

Image 43
Contents MVR430MG/MVR630MG VCR Dear Magnavox product owner Warranty VerificationTable of Contents Declaration of Conformity FeaturesSafety Precautions IntroductionVCR maintenance Before Using Your VCRPutting Batteries in the Remote Control Battery SafetyDisconnect the antenna or cable from your TV Hookups Without a Cable Box/Direct Broadcast SystemCH3 CH4 Connections Hookups With a Cable Box/Direct Broadcast SystemRecording/Viewing Any Channel Connect a Cable signal to the VCR’s ANTenna in Jack Signal RF coaxial cable TV’s AntennaRecording One Channel/Watching Another MVR630MG Hookups with a Stereo TVPress the Menu button. The display shown below will appear Correctly. Details are on pagesPress the Menu button Automatic Channel SetupMVR630MG only Adding/Deleting Channels Automatic Channel Setup cont’dPress the STATUS/EXIT button once or twice to exit Reviewing Memorized ChannelsEnter a 0 before a single-digit number Setting the ClockVCR may lose the clock setting if the power fails ButtonDaylight-Savings Time Press the STATUS/EXIT button Language SelectionRemote Control Buttons CHannel o/p Button Remote Control Buttons cont’dIf you select Status ON, then select Counter only OFF If you select Status ON, then select Counter only onIf you select Status OFF VCR Display Panel Front Panel Rear Panel 1Turn on the TV 2Insert a tape in the VCR Other playback options and features are on pagesPlaying Read and follow the steps below to play a tapeFor recording options, see pages VCR records in a preset volumeRecording To stop recording, press the STOP/p buttonPanel again Recording One Channel/Watching AnotherPress the VCR/TV button to put the VCR in VCR Position. The VCR/TV light will appear on the VCR displayTon once When the OTR finishes, the VCR shuts itself offOne-Touch Recording Turn itself offDaily Timer RecordingSet the clock. Details are on Do each step within 60 seconds of the previous stepInstructions continue on Timer Recording cont’dTape Speed T160 T120 T60 This timeTape Speeds Cassette type/Playback TimeChecking or Cancelling Timer Recordings VCR Rerecording Tape DuplicationMake the connections shown above VCR 1 will play your tape. Put a prerecorded tapeRepeat Play Press the PLAY/o button to watch the tape Real-Time Counter MemoryPress the Time Search button Time SearchViewing a Still Picture Special Effects PlaybackForward and Reverse Searching SP/LP/SLP Super High Speed Searching LP/SLPAutomatic Operation Features Monaural Sound Understanding On-Screen DisplaysMonitor Or ReceiverMulti-Channel Television Sound System MVR630MG only cont’d Please see additional notes on Hi-Fi Stereo Sound System MVR630MG onlyBlue Background Helpful Hints Helpful Hints cont’d English or Spanish Speaking Shipping charges to return defective productProduct sold AS is or Renewed Contact Magnavox Customer Care Center atSpecifications Glossary / SpecificationsGlossary Audio in/out jacks PowerTimer Record Remote controlSupplied Accessories