Setting the Antenna and Channel Memory
TUNER/CHANNEL MENU
1: ANTENNA IN | - STD CATV |
2:AUTO PROGRAM
3:SET CHANNEL MEMORY
4: TUNER AUDIO | - STEREO |
MENU KEY FOR PREV MENU
SELECT KEY TO CHOOSE ARROW KEYS TO CHANGE
Once you have your 8mm/VHS
1.Press MENU on your remote control until the SETUP MENU appears on your screen. You may have to press MENU more than once.
2.Press SELECT to choose the TUNER/CHANNEL MENU.
3.Set the ANTENNA IN. Press SELECT repeatedly to cycle through these choices: TV, STD CATV, HRC CATV, IRC CATV. If you don’t subscribe to cable television, select TV. If you subscribe to cable television, you will most likely select STD CATV. Call your cable company if you are uncertain about which setting to use.
4.Using the TRK/MENU ▼ and ▲ keys or the numerical keys, move to the AUTO PROGRAM item. Press SELECT to begin automatic channel programming. The VCR will go through all the possible TV and cable channels, and will automatically put the channels which you receive into Channel Memory. This will take a few minutes to complete.
5.If you wish, you can program certain channels into or out of Channel Memory manually. To do this, see the TUNER/CHANNEL MENU section of the Setup Menu chapter in the Reference Guide.
6. | Press QUIT | to save these changes and to exit the menu |
| system. |
|
Unless you have a cable converter box, you can now use the remote control to change channels. If you have a cable converter box, you must keep your 8mm/VHS Dual- Deck VCR tuned to the channel that your cable company uses (call your cable company for this information), and you must use the cable converter box to change channels.
RECEIVING CABLE AND TV SIGNALS 9