Fujitsu PG-DTA101 manual Appendix LCD Messages

Appendix LCD Messages

There are 3 types of LCD messages:

E : Error messages

I : Informational messages

S : Status messages

LCD Message	Type	Light Status	Meaning
At BOD	E	On	A SPACE command encountered an unexpected
			BOD (Beginning of Data).
			The tape is now positioned at the BOD.
At EOD	E	On	A READ or SPACE command encountered an unex-
			pected EOD (End of Data).
			The tape is now positioned at the EOD.
Bad Media	E	Flashing	A READ or SPACE command has failed because
			the tape is not in DDS format.
			Action: Unload the tape and use a DDS-certified
			(Media Recognition System) tape.
Cannot Write	E	Flashing	A WRITE, WRITE FILEMARK or ERASE command
Non-MRS Tape			has been attempted on a non-Media Recognition
			System tape.
			Action: Remove the cartridge and replace it with a
			Media Recognition System cartridge.
Clean fail:	E	Flashing	Cleaning failed, possibly due to an expired tape.
Check Cleaning			Action: Use a new cleaning cartridge.
Tape
Clean Me	E	Flashing	A high error rate has been detected while reading or
			writing.
			Action: Insert a cleaning cartridge to clean the tape
			heads, ensuring that the tape in the cleaning car-
			tridge has not been used up.
Cleaning	S	—	A cleaning cartridge has been loaded into the drive
			mechanism.
Close Door	E	Flashing	The autoloader does not work because the front
			panel door is open.
			Action: This is probably caused by a magazine that
			is not fully inserted into the autoloader. Insert the
			magazine fully into the autoloader or remove it.
Drive Comms	E	On	The drive has stopped communicating with the
Error			changer mechanism.
			Action: Call for service.
Drive fault	E	—	The drive has detected an internal error.

22