Fujitsu PG-DTA101 manual Hardware Error Codes

!Hardware Error Codes

The table below explains the various hardware error codes that may appear on the LCD panel as the message “Error X.” When such an error occurs, call for service and inform the service representative of the value of “X.”

The value of X		Description of the hardware error
8 - 13		The Z-motor jammed while loading or ejecting the magazine.
16	- 21	The Z-motor has not responded within the time-out period.
24, 25		A magazine load was attempted, but no magazine was in the autoloader. This
		should never occur and indicates a firmware error.
32	- 38	The R-motor is jammed, failing to rotate the carousel.
40	- 46	The R-motor has not responded within the time-out period.
48	- 55	The Y-motor has not responded within the time-out period on upward motion.
56	- 63	The Y-motor is jammed on upward motion.
64	- 71	The Y-motor is jammed on downward motion.
72	- 79	The X-motor is jammed with the picker arm forward or backward.
80	- 87	The X-motor has not responded within the time-out period.
88	- 93	There is no cartridge on the platform when one was expected.
96	- 101	There is a cartridge on the platform when there should not be.
104 - 107		The door is open after a magazine has been inserted, or after an attempt to lock it.
112 - 117		A cartridge in the picker fingers has become loose.
120 - 121		The tape has not been loaded in the drive successfully, even though the changer
		mechanism has apparently delivered it successfully.
128 - 132		The X-motor is jammed.
136 - 140		The X-motor has not responded within the time-out period.
144		The diagnostic to test sensor status detected that the sensor is inactive. This is
		not necessarily a fault.
152 - 159		The Y-motor has not responded within the time-out period on downward motion.
160, 161		A cartridge has been accidentally pushed into the drive. The cartridge was then
		either physically loaded, or ejected and returned to the magazine.
168, 169		A cartridge has been inserted into the drive, but has not been successfully loaded
		or ejected.
176		The door has failed to open.
184, 192, 200		An undefined or unrecognizable internal command has been detected.
208		The current magazine location already has a cartridge in it.
216		The host has sent a LOG SENSE or LOG SELECT command with an invalid
		page code.
224		The host has issued a command with an invalid magazine slot (that is, not in the
		range 1-6).
232		The current magazine slot is empty, when it was expected to contain a cartridge
240		A diagnostic has been sent, but the autoloader is not in diagnostic mode.
248		Communications between the drive and the front panel display have been
		aborted. This is an internal error code. If it is reported over SCSI, it indicates a
		firmware error.

Appendix LCD Messages 27

E