Fujitsu PG-DTA101 manual Lative compression ratio since power-on, or since

Tape Stuck	E	Flashing	The cartridge is stuck in the drive.
			Action: Try forcing ejection. If this fails, call for ser-
			vice.
Unloading	S	—	Either the drive is unloading a cartridge, or a car-
			tridge is being ejected from the drive and replaced in
			the magazine.
UpgradeErr	E	Flashing	An error occurred while upgrading the firmware.
Worm Media	E	Flashing	A high error rate has been detected while writing,
			suggesting that the tape is nearing the end of its
			useful life.
			Action: Copy any data you wish to keep from the
			cartridge onto a new cartridge and discard the old
			cartridge.
Write x.y	S	—	The drive is writing data to tape. “x.y:1” is the cumu-
			lative compression ratio since power-on, or since
			the compression ratio was last cleared. For exam-
			ple, “Write 2.1” means a compression ratio of 2.1:1.
			The compression ratio will only be displayed if 1 MB
			or more data has been written since power-on.
Write Fail	E	Flashing	A WRITE, WRITE FILEMARK or ERASE command
			has failed.
			Action: Use a new cartridge.
Write Fail:	E	Flashing	The drive could not write to the tape, which may be
Clean or Use New			worn or damaged.
Tape			Action: Insert a cleaning cartridge to clean the tape
			heads, ensuring that the tape in the cleaning car-
			tridge has not been used up, or use a new cartridge.
Write Protected	E	Flashing	A WRITE, WRITE FILEMARK or ERASE command
Tape			has been attempted on a write-protected cartridge.
			Action: Remove the cartridge and change it to write-
			enabled.
Wrong FW	E	Flashing	The upgrade firmware is not compatible. The origi-
			nal firmware is not changed or modified.

26