Getting Started
English
Checking the Supplied Accessories
Check to be sure you have all of the following supplied accessories. The number in the parentheses indicates the quantity of the pieces supplied.
•Remote Control (1)
•Batteries (2)
•Audio cord (2)
•Optical digital cord (1)
If anything is missing, contact your dealer immediately.
Putting Batteries in the Remote Control
Before using the remote control, put two supplied batteries first.
•When using the remote control, aim the remote control directly at the remote sensor on the unit (at a distant of up to 23 feet — 7 m).
Connecting the Unit
You need to connect this unit to an amplifier/receiver and some playback components such as CD player, Compact Component System.
The illustration on the next page indicates a typical connection with a CD player and an amplifier.
Remember NOT to turn on the power until all the connections have been completed.
Analog Connection
•For recording on this unit: Connect an audio cord between the ANALOG IN jack on this unit and Line Output jack on the playback equipment — e.g.
•For playback or recording on the other unit: Connect an audio cord between the ANALOG OUT jack on this unit and Line Input jack (e.g.
1.On the back of the remote control, remove the battery cover.
2.Insert batteries. Make sure to match the polarity:
(+) to (+) and
3. Replace the cover.
Digital Connection — Coaxial ı
Connect a coaxial digital cord between the COAXIAL OUT terminal on this unit and the Digital Coaxial Input terminal (e.g. COAXIAL IN) on an amplifier or another digital recording component.
Digital Connection — Optical
Before connecting optical cables, disconnect the protective caps from the OPTICAL IN and OUT terminals.
•For recording on this unit: Connect an optical digital cord between the OPTICAL IN terminal on this unit and the Digital Optical Output terminal on a playback component — e.g. OPTICAL OUT on the CD player.
•For playback or recording on the other unit: Connect an optical digital cord between the OPTICAL OUT terminal on this unit and the Digital Optical Input terminal (e.g. OPTICAL IN) on an amplifier or another digital recording component.
Notes:
•It is not required to do all three connections. You can connect your components and this unit using only one or two of the connections listed above.
•It is recommended to use one of the digital connections to obtain the optimum recording quality on this unit.
If the range or effectiveness of the remote control decreases, replace the batteries. Use two
CAUTION:
Follow these precautions to avoid leaking or cracking cells:
•Place batteries in the remote control so they match the polarity: (+) to (+) and
•Use the correct type of batteries. Batteries that look similar may differ in voltage.
•Always replace both batteries at the same time.
•Do not expose batteries to heat or flame.
5