JVC DR-MH30B, DR-MH20B manual Auto Set Up, Number Set, Before starting, make sure of the following

Filename [DR-MH30EU_04Name.fm]
DR-MH30EU_00.book Page 20 Thursday, June 3, 2004 11:00 AM	Masterpage:Left0

20 EN INITIAL SETTINGS

	Auto Set Up	ATTENTION:
		“AUTO” blinks on the front display
			INITIAL SET UP > AUTO SET
		panel; do NOT press any button on
Auto Channel Set/Auto Clock Set/Auto Guide Program
		the unit or remote control until the
		front display panel shows “– –:– –”
Number Set					AUTO SET
		as illustrated on page 22.			PLEASE WAIT...
		● When you have connected the unit
		to a TV offering T-V Link via a
After the 1 button on the unit (or DVD 1 on the remote		fully-wired 21-pin SCART cable	SET UP	ENTER SELECT WITH [ ] THEN PRESS [ENTER]
			EXIT		PRESS [SET UP] TO EXIT
control) is pressed for the first time to turn on the unit, the Auto		( pg. 19) and the TV is turned		SELECT
Set Up function sets the tuner channels, clock** and Guide		on, the unit automatically performs
Program numbers automatically.		the Preset Download ( pg. 21) even if you select “AUTO SET” for
		Auto Set Up function.

1

CABLE/DBS

TV DVD

DVD1

ENTER

rtwe

ATTENTION:

Once you have performed Auto Set Up, even if the unit’s memory backup has expired, all the stored stations and their Guide Program numbers remain in the unit’s memory and the unit will not perform Auto Set Up again. The unit only performs Auto Clock Set when the unit is turned on.

If you have moved to a different area, perform each setting as required.

●Tuner setting ( pg. 72)

●Clock setting ( pg. 75)

If a new station starts broadcasting in your area, perform tuner setting. ( pg. 72)

NOTES:

●In areas where no TV station transmits a PDC (Programme Delivery Control) signal, the unit can perform neither Auto Clock Set nor Auto Guide Program Number Set.

●If there is a power cut, or if you press 1 or SET UP while Auto Set Up is in progress, Auto Set Up will be interrupted; be sure to turn off the unit power once and try again from step 1.

●Auto Clock Set may not function properly depending on the reception condition.

After “Auto Set Up” is completed, perform “Monitor Set” on page 24.

Before starting, make sure of the following:

●The TV aerial cable should be connected to the unit.

●The unit’s mains power cord should be connected to a mains outlet.

●Turn on the TV and select the AV mode.

●Slide the TV/CABLE/SAT/DVD switch to DVD.

1Press 1 on the unit or DVD 1 on the remote control to turn on the unit. The Country Set display appears on the TV screen. The AUTO SET/T-V LINK display appears on the TV screen.

2 Press w e to select “AUTO SET”, then press ENTER. The AUTO SET screen will appear.

INITIAL SET UP > AUTO CH SET

AUTO SET T-V LINK

TEST MODE

SET UP	ENTER	SELECT WITH [	] THEN PRESS [ENTER]
		PRESS [SET UP] TO EXIT

EXIT SELECT

Page 20

Thursday, 3 June 2004 10:46