JVC DR-MH20B, DR-MH30B manual Preset Download, Set/Auto Guide Program Number Set

Filename [DR-MH30EU_04Name.fm]
DR-MH30EU_00.book Page 21 Thursday, June 3, 2004 11:00 AM	Masterpage:Right+
	INITIAL SETTINGS EN 21

	Preset Download	If you have connected the unit to your TV via a 21-pin SCART
		cable ( pg. 19), the unit will automatically perform Preset
		Download instead of the Auto Set Up in step 2 on page 20. After
Auto Channel Set by Downloading from TV/Auto Clock
		downloading, the unit sets the clock and Guide Program numbers
Set/Auto Guide Program Number Set		automatically.
		● Slide the TV/CABLE/SAT/DVD switch to DVD.

ATTENTION:

You can use this function only with a TV offering T-V Link, etc.* Be sure to use a fully-wired 21-pin SCART cable.

* Compatible with TVs offering T-V Link, EasyLink, Megalogic,

1Press 1 on the unit or DVD 1 on the remote control to turn on the unit. The Country Set display appears on the TV screen. The AUTO SET/T-V LINK display appears on the TV screen.

SMARTLINK, Q-Link or DATA LOGIC via a fully-wired 21-pin SCART

cable. The degree of compatibility and available functions may differ by

system.

CABLE/DBS

TV DVD

DVD1

ENTER

we

2Press w e to select “T-V LINK” and press ENTER. The T-V LINK screen will appear.

ATTENTION:

Preset positions on the front display panel increase from “PR 1”; do NOT press any button on the unit or remote control until the front display panel shows clock time, “PR 1” or “– –:– –” as illustrated on page 22.

●When Preset Download is completed, “COMPLETED” appears for about 5 seconds, then the normal screen appears.

●If you press any button on the unit or remote control while downloading is in progress, it will be interrupted.

NOTES:

INITIAL SET UP > AUTO CH SET

AUTO SET T-V LINK

TEST MODE

SET UP	ENTER	SELECT WITH [	] THEN PRESS [ENTER]
		PRESS [SET UP] TO EXIT

EXIT SELECT

INITIAL SET UP > AUTO SET

AUTO SET

PLEASE WAIT...

SET UP	ENTER	SELECT WITH [	] THEN PRESS [ENTER]
		PRESS [SET UP] TO EXIT

EXIT SELECT

SET UP

●For details, refer to the instruction manual of your TV.

●In the area where no TV station transmits a PDC (Programme Delivery Control) signal, the unit can perform neither Auto Clock Set nor Auto Guide Program Number Set.

●If there is a power cut, or if you press 1 or SET UP while downloading or set up is in progress, it will be interrupted; be sure to turn off the unit power once and try again from the beginning.

●Auto Clock Set may not function properly depending on the reception condition.

●On this unit, the characters available for station names (ID) are A–Z, 0–9, –, f, + and I (space). Some names of downloaded stations may differ from those of your TV. ( pg. 74)

After “Preset Download” is completed, perform “Monitor Set” on page 24.

Page 21

Thursday, 3 June 2004 10:46