JVC DR-MH30B, DR-MH20B manual An invalid PlusCode number has been input.  pg

Filename [DR-MH30EU_10Subsidiary.fm]
DR-MH30EU_10Subsidiary.fm Page 82 Thursday, June 3, 2004 4:57 PM	Masterpage:Left+

82 EN TROUBLESHOOTING

PlusCode NO. ERROR

CONFIRM PlusCode NO. THEN RETRY

●An invalid PlusCode number has been input. ( pg. 46)

GUIDE PROGRAM IS NOT SET

SET GUIDE PROGRAM THEN RETRY

●To set the timer programme using the VIDEO Plus+ system, the Guide Program number must be set in advance. ( pg. 72)

CAN NOT SET VIDEO Plus+ TIMER PROGRAMMING DURING TIMER RECORDING OR INSTANT TIMER RECORDING

●Appears when you tried to input a PlusCode number during timer recording or instant timer recording.

REGION CODE ERROR

CHECK DISC

●A disc loaded cannot be played back on this unit since the region number of the disc does not match that of the unit. ( pg. 7)

UNREADABLE DISC

CHECK DISC

●When an incompatible disc is loaded, 4 has been pressed. ( pg. 7)

COULD NOT FORMAT THE DISC

CHECK THE DISC

●Formatting is not complete since the disc may be dirty or damaged. Take out the disc, clean it and retry. ( pg. 10, 76)

CAN NOT FINALISE THIS DISC

●Finalising is not complete since the disc may be dirty or damaged. Take out the disc, clean it and retry. ( pg. 10, 77)

CAN NOT CANCEL FINALISATION

OF THIS DISC

PRESS [STOP] AGAIN TO STOP RECORDING

●During Live Memory playback, 8 has been pressed. ( pg. 44)

TIMER RECORDING COMPLETED

●Timer recording has finished during Live Memory playback.

PLAYBACK WILL STOP

THEN TIMER RECORDING WILL START

●Timer recording finished during Live Memory playback, then the next timer recording is about to begin while playback continues.

COPY PROHIBITED

CAN NOT RECORD

●An attempt has been made to record copy-protected contents.

●An attempt has been made to record copy-once contents on a disc that is not CPRM compatible, such as DVD-R.

COPY PROHIBITED

CAN NOT PLAY

●The unit has detected invalid contents at the start or in the middle of playback.

THE i.LINK DEVICE THAT YOU HAVE CONNECTED IS NOT RECOGNIZED

MAKE SURE THAT THE DEVICE IS CONNECTED PROPERLY AND POWERED ON

●An attempt has been made to start DV dubbing when a digital video camera is not properly connected to the unit.

●Check the connection. ( pg. 60)

●Cancelling disc finalisation is not complete since the disc may be dirty or damaged. Take out the disc, clean it and retry. ( pg. 10, 77)

Page 82

Thursday, 3 June 2004 16:57