JVC DR-MH30B, DR-MH20B manual Or An Amplifier With Built-in DTS

Filename [DR-MH30EU_09Editing.fm]
DR-MH30EU_00.book Page 68 Thursday, June 3, 2004 11:00 AM	Masterpage:Left+

68 EN SYSTEM CONNECTIONS

Connecting To A Dolby Digital Decoder	When you can’t switch the audio channel of a bilingual
	programme
Or An Amplifier With Built-in DTS	When the unit is connected with a digital audio device using an
	optional optical cable and “DIGITAL AUDIO OUT” is set to “DOLBY
	DIGITAL/PCM”, it is not possible to switch the audio channel of a
These instructions enable you to connect your unit to a Dolby	bilingual programme recorded on a DVD-RAM or DVD-RW (VR
Digital decoder or an amplifier with built-in DTS.	mode) disc. In this case, perform the following steps using the
	remote control to switch “DIGITAL AUDIO OUT” from “DOLBY
	DIGITAL/PCM” to “PCM ONLY”. ( pg. 31)
	A Press SET UP to access the Main Menu screen.
	B Press w e to select “DVD VIDEO SET UP”, then press ENTER.
	C Press w e to select “AUDIO OUTPUT”, then press ENTER.
	D Press rt to select “DIGITAL AUDIO OUT”, then press
	ENTER.
	E Press rt to select “PCM ONLY”, then press ENTER.
	( pg. 69)
Dolby Digital Decoder or	F Press SET UP to complete the setting.
	G Press AUDIO to select the desired audio channel.
amplifier with built-in DTS

To DIGITAL AUDIO input

Optical cable (not provided)

Coaxial cable (not provided)

DIGITAL OUT (COAXIAL)

DIGITAL OUT (OPTICAL)

Note for connection:

Remove the protection cap from the cable.

1 Connect the unit and a Dolby Digital decoder or an amplifier with built-in DTS using either an optional optical cable or an optional coaxial cable.

NOTES:

●For Dolby Digital sound, set “DIGITAL AUDIO OUT” to “DOLBY DIGITAL/PCM”. ( pg. 69)

●For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/PCM”. ( pg. 69)

CAUTIONS:

●This unit has a dynamic range of more than 110 dB with regards to its Hi-Fi audio capability. It is recommended that you check the maximum level if you are going to listen to the Hi-Fi audio signals through a stereo amplifier. A sudden surge in the input level to the speakers may damage them.

●Some speakers and televisions are specially shielded to prevent television interference. If both are of the non-shielded type, do not place the speakers adjacent to the TV set as this can adversely affect the playback picture.

Page 68

Thursday, 3 June 2004 10:46