STEP 7: Connect AM and FM Antennas (supplied)
AM GND
Connections page 7/8
- OR - |
75Ω
The back of your Klipsch System has jacks for the AM and FM antennas that were packed with your system. Unwind the wires for each antenna to provide the best reception. An outdoor antenna may be used in place of the supplied indoor antennas. To add an outdoor antenna, consult a qualified installer.
Follow all safety instructions supplied with the antenna.
FM Antenna
Plug the FM antenna into the Klipsch system’s FM (75Ω) jack in the section labeled ANT. On the back of your Klipsch system, spread out the antenna arms and move them around to establish optimum FM reception. Extend the antenna as much as possible.
Some cable TV providers make FM radio signals available through the cable service to your home. This connection is made to the external FM jack on the back of the Klipsch system. To connect to this service, contact your cable TV provider for assistance.
Make sure that the cable radio installation includes a TV/FM splitter so that only the FM radio band, not the cable TV band, is received by the Klipsch system. If necessary, contact your cable company.
AM Antenna
Plug the AM loop antenna into the AM GND jack in the section labeled ANT on the back of your Klipsch system. Place the antenna loop at least 20 inches (50 centimeters) away from your Klipsch system. To get optimum reception, you may need to experiment with the positioning of the loop antenna.
STEP 8: Turn on the TV and the Klipsch System
1.Plug in the Klipsch system’s power cord to an AC power outlet.
2.Turn on the Klipsch system (press the ON/OFF button on the front panel or on the remote control). You can also press DISC on the remote.
3.Turn on the TV and tune to the correct video input channel. This is the channel that corresponds to the input jack you used on the back of the TV to connect the Klipsch system. The name and how you access this video input channel varies for different TVs. Generally, you will press a button on the TV’s remote control, such as SOURCE or INPUT or VID. See below if you can’t find the correct input channel on your TV.
Set TV to the Right Channel
If you do not see a picture on your TV, check your TV's owner manual to see how you tune the TV to the correct channel. It won't be "Channel 3" but it's the same idea. You'll need to tune the TV to the "channel" that matches the input jacks on the TV you used to connect to the Klipsch system's output jacks (either COMPONENT,
Button on TV Remote | Channel Number of TV | Button on TV | ||
SOURCE | 00 | 90 | 91 | SOURCE |
INPUT | 92 | 93 | VID 1 | INPUT |
LINE | VID | SVID | CMPNT | LINE |
VIDEO |
|
|
| VIDEO |
VID | You might have to press | VID | ||
| the TV's channel down |
| ||
| button until you get to the |
| ||
| correct video channel. |
| ||