JVC HR-XVC33UM manual Connect the unit to TV, Connect the unit to power source, Check the contents

Filename [XVC33UM_06Index.fm]
XVC33UM_06Index.fm Page 13 Tuesday, September 9, 2003 9:27 AM	Masterpage:Right0

INSTALLING YOUR NEW UNIT		EN 13
Basic Connections	C
		Connect the unit to TV.
	The connection method you use depends on the type of
	TV you have.
Antenna or Cable

Coaxial cable
Flat feeder
	Matching transformer
	(not supplied)
AC Outlet	AUDIO
	OUTPUT
AC Power Cord	VIDEO OUTPUT

PCM/STREAM

OPTICAL COAXIAL

Back of unit	VHF/UHF
	IN
Audio/video cable	VHF/UHF OUT
(not supplied)

RF Connection

8To connect to a TV with NO AV input connectors —

ADisconnect the TV antenna from the TV.

BConnect the TV antenna cable to the VHF/UHF IN connector on the rear panel of the unit.

CConnect the supplied RF cable between the VHF/UHF OUT connector on the rear panel of the unit and the TV’s antenna terminal.

AV Connection

8To connect to a TV with AV input connectors —

AConnect the antenna, unit and TV as per “RF Connection”.

BConnect an optional audio/video cable between the AUDIO/VIDEO OUTPUT connectors on the rear panel of the unit and the TV’s audio/video input

connectors.

●Set your TV to AV mode.

●For switching the TV’s mode, refer to the instruction manual of your television.

●To obtain high-quality pictures, you can also use the S-VIDEO

connection or Component Video Connection. (DVD deck only) ( pg. 14, 15)

D Connect the unit to power source.

Plug the end of the AC power cord into an AC outlet.

To Audio/video	RF cable
input connectors	(supplied)

To 75 ohm

Terminal

TV

It’s essential that your unit be properly connected.

THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.

A Check the contents.

Make sure the package contains all of the accessories listed in “SPECIFICATIONS” on page 89.

B Situate the unit.

Place the unit on a stable, horizontal surface.

E Set the VCR channel.

The VCR channel is the channel on which you can watch the picture from the unit on the TV when only using RF connection.

With RF connection, set the VCR channel to “3 CH” or “4 CH”.

●The VCR channel is preset to “3 CH”. Set to “4 CH” if the Channel 3 is used for broadcasting in your area.

With AV connection, set the VCR channel to “– CH” (off). To set the VCR channel, perform the following steps:

Before performing the following steps:

●Make sure there is no cassette inserted in the unit.

●Make sure the unit is turned on, then press VCR/ DVD on the unit or VCR on the Remote so that the VCR indicator lights up.

AWhen the unit is turned off, press STOP (8) on the unit for more than 5 seconds. “3 CH” appears on the front display panel.

BPress CH +/– on the Remote to select “3 CH”, “4 CH”

or “– CH” (off), then press OK.

●If Plug&Play or Tuner setting has not previously been performed, the Language Select screen appears and Plug&Play takes place automatically.

Page 13

9 September 2003 9:26 am