JVC E9770ED/1VMN manual Installing Batteries, Remote Control, VCR / DVD Recorder Switching, 12 EN

Page 12

 

 

 

 

 

 

 

 

 

 

 

 

 

Installing Batteries in the

Before

Remote Control

 

 

 

 

 

 

 

 

 

 

You

Install two R6 (AA) batteries (supplied) into the

remote control, carefully match with the polarity

Start

indicated inside the battery compartment.

1

2

 

 

3

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Caution

Incorrect use of batteries can result in hazards such as leakage and bursting.

Do not mix new and old batteries together.

Do not use different kinds of batteries together.

Make sure that the plus and minus ends of each battery match the indications inside the battery compartment.

Remove batteries if the equipment will not be used for a month or more.

When disposing used batteries, please comply with governmental regulations or the public instructions for environmental protection that apply in your country or area.

Do not recharge, short-circuit, heat, burn or disassemble batteries.

About the Remote Control

Make sure there is no obstacle between the remote control and the remote control sensor on the unit.

Use within the operating range and angle as shown.

Within about

DUBBING

5 m

 

 

 

 

 

60˚

-

 

 

 

-

 

1

 

 

4

 

2

 

7

5

3

 

8

 

6

 

0

9

 

 

Remote

Code (DVD): JVC C

control

Code (VHS): JVC A

Remote control operation may become unreliable if the remote control sensor of the unit is being exposed by the strong sunlight or fluorescent light.

Remote controls for different devices can interfere with each other. Be careful when using remote controls for other equipment located close to the unit.

Replace the batteries when the operating range of the remote control reduces.

VCR / DVD Recorder Switching

Because this product is a combination of a VCR and a DVD recorder, you must select first which component you wish to operate with [VCR/DVD] on the front panel.

 

 

 

 

DUBBING

 

 

 

 

 

VCR

PR

 

 

VCR/DVD

DVD

 

S-VIDEO VIDEO

L-AUDIO-R

VCR

DVD

 

VCR/DVD

VCR DVD

DVD light

VCR light

VCR mode

Press [VCR] on the remote control. (Verify that the VCR light is lit.)

DVD mode

Press [DVD] on the remote control. (Verify that the DVD light is lit.)

Note

Pressing only [VCR/DVD] on the front panel DOES NOT switch the mode of the remote control. You MUST select the correct mode on the remote control.

Press [VCR/DVD] to select the DVD mode or the VCR mode.

You cannot switch to the mode (DVD or VCR) that is in the timer-standby mode.

If the media is available, you can start recording by pressing [DVD REC I] or [VCR REC I] on the remote control even if another equipment (DVD or VCR) is selected. In this case, the mode of the remote control will be automatically switched to the appropriate component.

12 EN

Image 12
Contents DR-MV2SEU Precautions Laser SafetyPower Supply Accessories SuppliedInstallation Location Avoid the Hazards of Electrical Shock and FireMoisture Condensation Warning Maintenance About CopyrightTable of Contents Features RecordingPlayback EditingSymbol Description Functional Overview Front PanelRear Panel Remote Control 10 ENTimer button DVD/VCR Repeat button DVDZoom button DVD Audio button DVD/VCRInstalling Batteries Remote ControlVCR / DVD Recorder Switching About the Remote ControlDisc type and format mode DVD mode Press DVD firstVCR mode Press VCR first Guide to On-Screen DisplaysSetting Menus Easy Setting MenuAdvanced Setting Menu 14 ENDisc Protect VR mode only Title List / Playlist / OriginalFormat DVD-RW only FinaliseFront Panel Display Guide Display Messages16 EN Connecting to a TV Connecting to External EquipmentGetting Started ConnectionsDigital Audio for Better Sound Quality Only for DVD After You Have CompletedConnections 18 ENChannel Setting Auto TuningPress SET UP to exit Selecting the On-Screen Display OSD LanguageManual Tuning To Skip a Preset ChannelTo Select a Channel 20 ENSetting the Clock Auto Clock SettingSelect Clock using Cursor U / D, then press Enter Press SET UP to exit Press STANDBY/ON /I to turn offManual Clock Setting Selecting the TV Aspect Ratio22 EN If you have a standard TVRecording Information on DVD RecordingType of Discs Recording SpeedInformation on Copy Control Making Discs Playable in Other DVD Players Finalise24 EN Usable DiscsSetting Auto Chapter Formatting a DiscChoosing the Recording Format of a Blank DVD-RW Disc Selecting the Sound Mode Setting External Input AudioReformatting a Disc Manually 26 ENSetting Bilingual Recording Audio Basic RecordingTurn on the unit and insert a recordable disc Press DVDOne-Touch Timer Recording OTR Checking the Recording Picture and Sound Quality28 EN Press REC Monitor again to exitTimer Recording Enter the date using Cursor U / D, then press Cursor PPress Enter when all information required is entered Press TimerTo Stop the Timer Recording in Progress If the Timer Programming Did Not Complete Correctly30 EN Timer Recording Using Showview System E41 Power failure E42 No discVPS Video Programme System PDC Programme Delivery Control Press Clear to erase the selected programmeHints for Timer Recording Press SET UP or32 EN Showview button to exitSettings for External Equipment Connection to External EquipmentIf the recording time is partially overlapped If the recording time entirely overlapsDubbing Mode Recording from External Equipment34 EN Setting a Disc to Protect To cancel the disc protectSelect DVD→VCR using Cursor U / D, then press Enter Insert a recordable disc Stop mode, press SET UPTo cancel finalising DVD-RW only Finalising DiscsAuto Finalise 36 ENPlaying Back Discs Information on Playing Back DVDsPlayable Discs Colour SystemsBasic Playback Hint for DVD PlaybackPlaying Back a DVD-RW / DVD-R DVD+RW / DVD+R Disc Playing Back a DVD-Video / CD / Video CDPlaying Back Discs Using the Disc Menu Select an item using Cursor U / D / L / P, then press EnterPress DVD first Press MENU/LIST Press MENU/LIST to exit the disc menuPlaying Back a Disc Using the Title Menu Playing Back a Video CD Using the Title MenuPBC Function for Video CDs 40 ENCancelling and Recalling the PBC Function Special PlaybackResume Playback Fast Forward / Fast ReverseSkipping TV Commercials During Playback PauseStep by Step Playback Slow Forward / Slow Reverse PlaybackMarker Setup ZoomDuring playback, press Zoom Search Title / Chapter SearchTrack Search Direct SearchRepeat / Random / Programme Playback / Slide Show Time SearchRepeat Playback Select Random Play using Cursor U / D, then press Enter Random PlaybackProgramme Playback Slide ShowSwitching Audio Soundtrack Switching SubtitlesSelecting the Format of Audio and Video Press Audio during playback, and follow from stepSwitching Camera Angles Select the icon using Cursor L / P, then press EnterReducing Block Noise 48 ENEditing Discs in Video Mode EditingDisc Editing Guide to a Title ListEditing Titles Guide to Editing Title Names50 EN Press DVD first Follow steps 1 to 4 in Deleting TitlesSetting or Clearing Chapter Markers Press SET UPEditing Discs in VR Mode Original Editing Original Titles in VR ModeOriginal Deleting Titles 52 ENTo protect a whole disc DVD-RW VR mode only Original Protecting TitlesOriginal Releasing Titles from Protecting Press Enter againPlaylist Editing the Playlist in VR Mode Playlist Deleting TitlesPlaylist Deleting Parts of Titles Scene Delete 54 ENPlaylist Setting or Clearing Chapter Markers Playlist Editing TitlesAdding a chapter marker Deleting a chapter markerPlaylist Setting Pictures as Thumbnails Playlist Dividing a Title56 EN Picture is set as the thumbnailSelect Yes using Cursor L / P, then press Enter Playlist Combining TitlesPlaylist Adding Titles to a Playlist Playlist Deleting a PlaylistChanging the Setting Menu Tour of the Setting Menu58 EN Language Setting Disc Menu Language Default EnglishAudio Language Default Original Subtitle Language Default OFFDisplay Setting Audio Setting60 EN Dynamic Range Control Default on Fast Forward with Audio Default onDolby Digital conversion Default Stream Settings for Mpeg Default PCMParental Lock Default All Enter the current password using the Number buttonsDVD-Videos Parental Lock Level 62 ENSetting TV System Changing Video Out SystemRecording and One-Touch Timer Recording OTR VCR FunctionsPlayback Basic RecordingOne-Touch Timer Recording Index SearchAccidental erasure prevention REV rOther Operations Changing the Video Colour SystemHi-Fi Stereo Sound System 66 ENTroubleshooting Symptom RemedyOthers DVD VCR68 EN DVDVCR Error message Cause Solution 70 ENLanguage Code Language CodeGlossary 72 ENSpecifications Declaration of ConformityGeneral Recording74 EN Page DR-MV2SEU

0905TNH-FN-FN, E9770ED/1VMN specifications

The JVC E9770ED/1VMN,0905TNH-FN-FN is a high-performance multimedia receiver that combines cutting-edge technology with user-friendly features to deliver an exceptional audio-visual experience. Designed for modern vehicles, this receiver caters to the needs of those who seek both convenience and entertainment on the road.

One of the standout features of the JVC E9770ED is its large touchscreen display. The 6.8-inch display boasts a vibrant and clear resolution, ensuring that users can easily navigate their media options, access apps, and view navigation maps. The interface is highly intuitive, allowing for quick and seamless interactions. The customizable home screen permits users to personalize their experience, ensuring easy access to their most frequently used features.

In terms of audio performance, the JVC E9770ED delivers superior sound quality. The built-in amplifier provides ample power to drive various car speakers, while the advanced equalizer settings allow users to fine-tune their audio according to personal preferences or vehicle acoustics. Additionally, support for high-resolution audio formats ensures that listeners can enjoy their favorite tracks in rich detail.

Connectivity is another major highlight of this receiver. The JVC E9770ED supports Bluetooth technology, allowing for hands-free calls and wireless streaming from smartphones and other devices. This makes it easy for users to stay connected and enjoy their music without the hassle of tangled wires. Furthermore, it is compatible with both Apple CarPlay and Android Auto, enabling seamless integration with mobile devices and providing access to apps, navigation, and communication directly through the receiver's interface.

The JVC E9770ED also includes multiple input options to accommodate various media sources. With USB ports, auxiliary inputs, and support for SD cards, users can easily connect and play music from their favorite sources. Additionally, the receiver is equipped with AM/FM radio, complete with RDS functionality for enhanced radio experience.

In summary, the JVC E9770ED/1VMN,0905TNH-FN-FN is a versatile multimedia receiver that excels in both audio quality and user convenience. With its large touchscreen, powerful audio capabilities, extensive connectivity options, and support for high-resolution sound, this receiver is an ideal choice for anyone looking to enhance their driving experience with premium entertainment and connectivity features. It represents a perfect blend of style, technology, and performance for the modern driver.