Grizzly G0462 owner manual Adjusting Tailstock Position, To pivot the headstock

To pivot the headstock:

1.DISCONNECT LATHE FROM POWER!

2.Make sure the head lock lever is tight.

3.Pull the pivot lock pin out (see Figure 18) and pivot the headstock clockwise 90˚ or 180˚, as shown in Figure 19.

Pivot

Lock Pin

Head

Lock Lever

Figure 18. Pivot lock pin location.

Figure 19. Head set at 90˚ and 180˚.

4.Release the pivot lock pin. Make sure the pin has engaged in its detent by trying to rotate the headstock.

Adjusting Tailstock

Position

The tailstock is equipped with a cam-action clamping system to secure it. When the lock lever is tightened, a locking plate lifts up and secures the tool rest to the bed.

To re-position the tailstock along the bed, loosen the tailstock lock lever (see Figure 20), move the tailstock to the desired position, then re-tighten the lock lever.

Note: If the lock lever will not securely clamp the tailstock down onto the bed (either too loose or too tight), loosen or tighten the hex nut located on the underside of the tailstock in small increments to achieve the proper clamping pressure.

Tailstock

Lock Lever

Figure 20. Tailstock lock lever.

G0462 Wood Lathe (Mfg. Since 3/10) -19-