Grizzly G0462 owner manual Assembly, To mount the lathe to the stand

Assembly

To mount the lathe to the stand:

1.Stand the legs up approximately 41" apart, then get them reasonably aligned, as shown in Figure 10.

Figure 10. Stand legs approximately 41" apart to

prepare for mounting the lathe.

2.Use the help of additional people to care- fully lift the lathe onto the legs and align the mounting holes.

Note: The headstock end is the heaviest and usually requires two people lifting at that end.

G0462 Wood Lathe (Mfg. Since 3/10)

3.Secure the lathe to the legs with the (8) M8-1.25 x 35 cap screws and 8mm lock washers, as shown in Figure 11.

x 8

Figure 11. Securing lathe to the stand leg.

4.Install the tool rest lock lever to secure the tool rest, as shown in Figure 12.

Figure 12. Installing handle into tool rest.

-15-