Grizzly G0462 owner manual

Page 19

5.Listen to and watch for abnormal noises or actions. The lathe should run smoothly with little or no vibration or rubbing noises.

—Strange or unnatural noises should be investigated and corrected before operat- ing the machine further. Always unplug the machine when investigating or correcting any situation with the machine.

6.Turn the lathe OFF, then remove the yellow switch disabling key from the paddle switch, as shown in Figure 15.

7.Try to start the machine with the paddle switch.

—If the machine does not start, the switch disabling feature is working as designed.

—If the machine starts, immediately stop the machine. The switch disabling feature is not working correctly. This safety feature must work properly before proceeding with regular operations. Call our Tech Support at (570) 546-9663 for help

Figure 15. Removing switch disabling key from

the paddle switch.

G0462 Wood Lathe (Mfg. Since 3/10)

NOTICE

The spindle speed levers adjust the pulley width to change the spindle speed. To pre- vent damage to this mechanism, the lathe MUST be running before using the variable speed lever.

8.Turn the lathe ON.

9.Test the variable speed by pulling out the speed lever (Figure 16) and slowly turning the speed up, then down.

Variable

Speed Lever

Figure 16. Variable speed lever.

—The machine should speed up and slow down as you move the lever. If this is the case, then the test run is over and your machine is ready for normal operations.

—If the lathe has problems changing speeds, turn the lathe OFF, disconnect it from power, and refer to the troubleshooting chart on Page 31, or call our Tech Support at (570) 546-9663 for additional help.

-17-

Image 19
Contents Model G0462 Wood Lathe Page Table of Contents Machine Description IntroductionManual Accuracy Contact InfoModel G0462 identification G0462 Wood Lathe Mfg. Since 3/10 IdentificationMachine Data Sheet Tailstock Information Safety Instructions for Machinery SafetyUnattended OPERATION. Never­ leave­ Preventing Thrown Workpiece Additional Safety for Wood Lathes110V Operation Circuit RequirementsDescription Qty SetupNeeded for Setup UnpackingHex Wrenches 3, 4, 6mm Each InventoryBox 1 Inventory Figure Qty Hardware Bag Inventory Figure QtyBefore cleaning, gather the following CleanupSite Considerations Mounting Using Machine MountsBolting to Concrete Floors To mount the lathe to the stand AssemblyTest Run Power ConnectionTo test run the machine Page Operations Adjusting HeadTo position the headstock along the length of the bed To pivot the headstock Adjusting Tailstock PositionInstalling/Removing Spur Center Adjusting Tool RestTo install the spur center To install the live center Installing/Removing Live CenterTo remove the spur center To install the faceplate Installing/Removing FaceplateGouge Selecting Turning ToolsTypical spindle turning operation Spindle TurningSpindle Turning Tips To mount your workpiece to a backing block Using a Backing BlockFaceplate Turning Attaching Faceplate to WorkpieceOutboard Turning Sanding/Finishing Using the LatheG3165-1 x 12 TPI RH Threaded Insert G1082-4-Jaw ChuckG9863-8-PC HSS Lathe Chisel Set Model H6542 Robert Sorby 8-PC SetMaintenance Troubleshooting ServiceMotor & Electrical Symptom Possible Cause Possible Solution To replace the V-belt Aligning CentersReplacing V-Belt To align the centersWiring Safety Instructions Wiring & ElectricalVAC Bk Electrical Components & Wiring DiagramParts Description Parts ListMachine Labels Comments Warranty CardBOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCWarranty and Returns Warranty and ReturnsOrder Hours a DAY