Go-Video VR3840 manual Reset the DVD Recorder+VCR, If you observe any of the following symptoms

Troubleshooting (Continued)

Symptom	Cause	Solution
Cannot record or did not	The remaining blank space on the disc is	Use another disc.
record successfully.	insufficient.
	The source you are trying to record is copy-	You cannot record the source.
	protected.
	When setting the recording channel, the	Select the channel on the DVD
	channel is tuned on the TV’s own tuner.	Recorder+VCR’s built-in TV tuner.
	When recording to a Video mode disc, pro-	Use a VR mode formatted disc for copy-once
	grams that are copy-once protected cannot	material.
	be recorded.
Timer Recording not possi-	Clock in DVD Recorder+VCR is not set to	Set clock to correct time. See “Clock Set
ble.	correct time.	(Auto)” or “Clock Set (Manual)” on page 20.
	Timer has been programmed	Reprogram Timer. See “Timer Recording” on
	incorrectly.	page 44.
	TIMER indicator light does not appear after	Reprogram Timer.
	programming timer.
Stereo Audio Record	TV is not Stereo-compatible.	No solution.
and/or Playback not pres-
	Broadcast program is not in stereo format.	No solution.
ent.
	DVD Recorder+VCR A/V Out jacks are not	Make A/V connections. Stereo is available
	connected to TV A/V In jacks.	only via A/V output from DVD Recorder+VCR.
	DVD Recorder+VCR Audio/Video Out is not	Select AUX or A/V source as TV input.
	selected for viewing at the TV.
	DVD Recorder+VCR’s TV audio channel is	Set TV audio channel mode to Stereo. See
	set to SAP or MONO.	“Changing TV Audio Channels” on page 28.
	The remote control is not pointed at the	Point the remote control at the remote sensor
	remote sensor of the DVD Recorder+VCR.	of the DVD Recorder+VCR.
	The remote control is too far from the DVD	Operate the remote control within 23 ft (7 m).
Remote control does not	Recorder+VCR.
work properly.	There is an obstacle in the path of the	Remove the obstacle.
	remote control and the DVD Recorder+VCR.
	The batteries in the remote control are	Replace the batteries with new ones.
	exhausted.

Reset the DVD Recorder+VCR

If you observe any of the following symptoms...

The unit is plugged in, but the power will not turn on or off.

The front panel display is not working.

The DVD Recorder+VCR is not operating normally.

...you can reset the DVD Recorder+VCR as follows:

Press and hold the POWER button for at least five seconds. This will force the unit to power off.

Press the POWER button again to turn the unit back on.

Unplug the power cord, wait at least five seconds, and then plug it in again.

58