Sony CD-X1500 Important for U.K. Customers, Do not cut off the mains plug from this equipment

Page 2

IMPORTANT (for U.K. Customers)

DO NOT cut off the mains plug from this equipment.

DO NOT cut off the mains plug from this equipment.

If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer.

If nonetheless the mains plug is cut of

 

f, remove the

 

 

 

 

 

 

fuse and

dispose of the plug

immediately,

to avoid

 

 

 

 

 

a possible shock hazard by inadvertent connection

 

to the mains

supply.

 

 

If this product is not provided with a mains plug, or

one has to be fitted , then follow the instructions given below:

IMPORTANT: DO NOT make any connection to the larger terminal which is marked with the letter E or by the safety earth symbol c or coloured GREEN or GREEN-and-YELLOW.

The wires in the mains lead on this product are coloured in accordance with the following code:

BLUE

: NEUTRAL

BROWN

: LIVE

As these colours may not correspond with the coloured markings identifying the terminals in your plug proceed as follows:

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.

When replacing the fuse only a correctly rated

approved type should be used and be sure to re-fit

the fuse cover

.

IF IN DOUBT — CONSULT A COMPETENT

ELECTRICIAN.

For U.S.A

TO THE USER

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

a)Reorient or relocate the equipment and/or the receiving antenna.

b)Increase the separation between the equipment and receiver.

c)Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

d)Consult the dealer or an experienced radio/TV technician for help.

CAUTION

Changes or modifications to this equipments not expressly approved by TEAC CORPORATION for compliance will void the user's warranty.

2 TASCAM CD-X1500 DUAL CD PLAYER

Image 2
Contents CD-X1500 Important for U.K. Customers Do not cut off the mains plug from this equipment… Do not expose this apparatus to drips or splashes Safety Information Demensions Handling of discs Environmental conditionsBeware of condensation Main Unit Front Panel Main Unit Rear PanelQSEARCH key Remote Controller Top Panel0OPEN key WP.MODE / PGM keyYJog Wheel LCDTTAP / Display key USCRATCH keyRemote Controller Bottom Panel Remote Controller LCDCUE indicator Flash indicatorMemory bank indicators RDY indicatorCUE Flash StartB Looping Key Original Adjusting the tempoPitch Bending Scratching Key controlBrake Set the brake timeMemory data Track Memory / RecallTrack Memory RecallAuto Cue Fader StartRelay Play Auto ReadyEdit program Programmed PlayCreate the program Insert programPress FLASH/DEL key Repeat Preset menuDelete program Backup Memory Preset Number Parameter * default FunctionError Messages Consulte cualquier posible reparación únicamente Para almacenar los puntos de Reproducción tartamuda con la tecla CUEReproducción tartamuda con Cambio del punto de final deManejo de los discos Condiciones ambientalesCuidado con la condensación Unidad principal panel frontal Unidad principal panel traseroQTecla Search Mando a distancia Panel superior0Tecla Open WTecla P.MODE / PGMDTecla PLAY/PAUSE YRueda Jog RLCDTTecla TAP / Display STecla CUE FTeclas de salto de pistaMando a distancia Panel inferior Mando a distancia LCDIndicador A.CUE Indicador FlashIndicadores de banco de memoria Indicador A.RDYReproducción tartamuda con la tecla Inicio flashPara memorizar el punto CUE Para memorizar los puntos CUEBucle A-B Clave original Ajuste del tempoInflexión tonal Ajuste del tiempo de frenado Control de claveFrenado Cuando ajuste el rango del tempo y del control deDatos memorizados Memoria de pista / cargaMemoria de pista CargaReproducción consecutiva Búsqueda automáticaInicio por fader Espera automáticaCreación del programa Reproducción programadaEdición del programa Inserción de programaMenú preset Borrado de programaValor por defecto Número preset Elemento ParámetroCopia de seguridad Mensajes de error Teac Corporation