LG Electronics MW 71PY10 PIP Input Select Command2y, Abnormal State Command2z, Key Command2c

External Control Device Setup

21. PIP Input Select (Command2:y)

GTo select input source for sub picture in PIP mode.

Transmission

[k][y][ ][Set ID][ ][Data][Cr]

Data	1	: Video1	6	: DVI
	2	: Video2	7	: Video3
	3	: Component1	8	: Video4
	4	: Component2	9	: HDMI
	5	: RGB
Acknowledgement
[y][ ][Set ID][ ][OK][Data][x]
Data	1	: Video1	6	: DVI
	2	: Video2	7	: Video3
	3	: Component1	8	: Video4
	4	: Component2	9	: HDMI

5: RGB

22.Abnormal State (Command2:z)

G To recognize an abnormal state.

Transmission

[k][z][	][Set ID][ ][FF][Cr]
Data	FF:Read
Acknowledgement
[z][ ][Set ID][ ][OK][Data][x]
Data	0: Power on(signal)	6: AC detect off
	1: Power on(No signal)	7: Fan Alarm off
	2: Remote control off	8: Off timer off
	3: Sleep time off	9: No signal off
	4: RS-232C off	a: Connection Detect off

5:5V monitor off

*If you do not press any button within 2 hours after the monitor turns on with the On Timer function, the monitor will automatically revert to standby mode.

24. Low Power (Command2:q)

G To control the low power function on/off.

Transmission

[j][q][ ][Set ID][ ][Data][Cr]

Data 0: Low power off 1: Low power on

Acknowledgement

[q][ ][Set ID][ ][OK][Data][x]

Data 0: Low power off

1:Low power on

25.Picture Size Setting for DW mode (Command2:t)

G To adjust main picture size in DW mode.

Transmission

[j][t][ ][Set ID][ ][Data][Cr]

Data Min: 0 ~ Max: 30

•Refer to ‘Real data mapping1’. See page 34. Acknowledgement

[t][ ][Set ID][ ][OK][Data][x]

Data Min: 0 ~ Max: 30

26. Auto Configure (Command2:u)

G To adjust picture position and minimize image shaking automatically. Auto Configure only works in RGB-PC mode.

Transmission

[j][u][ ][Set ID][ ][Data][Cr]

Data 1

•Refer to ‘Real data mapping1’. See page 34. Acknowledgement

[u][ ][Set ID][ ][OK][Data][x]

Data 1

23. ISM Method (Command2:p)

G To avoid having a fixed image remain on screen.

Transmission

[j][p][	][Set ID][ ][Data][Cr]
Data	0: Normal	2: Orbiter
	1: White wash	3: Inversion
Acknowledgement
[p][ ][Set ID][ ][OK][Data][x]
Data	0: Normal	2: Orbiter
	1: White wash	3: Inversion

27. Key (Command2:c)

G To adjust Key code for IR remote control.

Transmission

[m][c][ ][Set ID][ ][Data][Cr]

Data Key code : Refer to See page 38.

Acknowledgement

[c][ ][Set ID][ ][OK][Data][x]

36 Plasma Monitor