®
QuickSet II Programmer
LT2002
ZENITH ELECTRONICS CORPORATION, LINCOLNSHIRE, ILLINOIS, USA
P A G E 2
• slow
Blink pattern
power on
no communications
• heartbeat power on communications ok
• green
• red
Color battery ok battery low
Reset
MPI
Status
Indicator
Connect cable to TV MPI Jack and follow on screen instructions
LT2002 Clone Programmer
As the cloning procedure is being performed, specific steps need to be done at the indicated times to achieve the desired result. Be sure to do each cloning task as indicated. If a procedure or step is left
out or not performed correctly, then the TV
setup will be wrong and cloning may not work. At each step, pay attention to assure the TV screen shows the proper message(s) when cloning. If the message indicated does not appear, there is a problem with that step and cloning may not be successful. Cloning is only possible when the signal source is an Analog channel, not a digital channel.
Installer Overview
This is the commercial mode setup guide only. For all other information refer to the separately-supplied TV Owner’s Manual (Users guide).
Operating Installer Menu
To set up the controls for the TV you will need to know how to enter the TV Installer menu and make changes to the default values as required. If necessary, familiarize yourself with the TV Installer menu and how to make and save changes in the menu.
LG Installer Remote
You will need an LG Installer remote control similar to the one shown to the right. The installer remote must have a “Source” but- ton or its equivalent. The remote shown in this manual has “INPUT” -- this button serves the purpose of a Source button.
The TV’s clonable features need to be set up. This is a critical step. If the Master TV display panel’s clonable features like adding channel icons or channel labels are not done properly, then the cloned TV TVs will all have problems. Refer to the Owner’s Manual for other TV features: Video, Audio etc.
PTC INSTALLER MENU
000 INSTALLER SEQ | 000 |
|
|
UPN | FPGA E0F1 |
PTC V1.00.000 | CPU V3.06.00 |
|
|
Typical Installer Menu
INPUT |
|
| MODE |
TV | POWER | TV | |
INPUT |
|
| DVD |
MULTI |
|
| VCR |
PIP | PIP CH - | PIP CH + | PIP INPUT |
EZ PIC | EZ SOUND | SWAP | INFO |
CC MENU RATIO
EXITSAP
ENTER
| TIMER |
VOL | CH PAGE |
MUTE
1 2 3
4 5 6
7 8 9
0FLASH BACK