Cloning Connections/Teaching Setup
Teaching the Master Setup to Another TV
Connections for the LT2002 to Teach another TV the Master Setup
Antenna
or CATV
Ferrite Core (TDK, ZCAT
2035-0930)
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION | XX | ||
THE TV IS VERSION | XX | ||
THE SW IS REVISION | XX | ||
CLONE CLOCK = | XX:XX |
| |
TV CLOCK | = | XX:XX |
|
Connect cable to |
|
|
|
|
TV MPI Jack and |
|
| Status | |
follow on screen |
|
| ||
instructions |
| Indicator | ||
|
|
|
|
|
MPI
Reset
Color | ||
• green | battery ok | |
• red | battery low | |
Blink pattern |
| |
• slow | power on | |
| no communications | |
• heartbeat | power on | |
| communications ok | |
|
|
|
QuickSet II Programmer
LT2002
ZENITH ELECTRONICS CORPORATION, LINCOLNSHIRE, ILLINOIS USA
Target TV | Clone Programmer |
| |
|
|
Teach Master TV’s Setup to the target TV
After learning is complete, remove the M.P.I. cable from the master TV and connect it to the target TV that you want to copy the master TV’s setup into. With “THE CLONE HAS CONTROL OF TV” message displayed, press 2 or use either Channel key to go to the “TEACH TO TV” option, press ON/OFF, POWER, or ENTER. Select the LT2002 memory that the new setup is in. Press On/Off to transfer the new setup and other
information to the new TV. Teaching usually takes
any key to return to the Clone menu, then press ON/OFF, POWER, or ENTER. If finished, detach M.P.I. cable from the target,
Disconnect TV Power for 15 Seconds
Unplug the AC power cord of the
CLONE SELECTION MENU
(1)LEARN FROM TV
(2)TEACH TO TV
(3)SET CLONE CLOCK FROM TV
(4)SET TV CLOCK FROM CLONE
(5)DISPLAY TV SETUP
(6)DISPLAY CLONE SETUP
This menu should appear after any key is pressed on the Installer remote.
TEACHING IN PROGRESS,
PLEASE WAIT
This display will appear during Teaching function.
TEACHING COMPLETE
This display will appear after Teaching is complete.
P A G E 9