Peerless Industries SUF660P manual Installing Adapter Brackets

Page 6

Installing Adapter Brackets

WARNING

Tighten screws so adapter brackets are firmly attached. Do not tighten with excessive force. Overtightening can cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.

If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly secured, damage may occur to screen or product may fail.

To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen. Place

2screen face side down. If screen has knobs on the back, remove them to allow the adapter brackets to be attached. Place adapter brackets (B) on back of screen, align to holes, and center on back of screen as shown below. Attach the adapter brackets to the back of the screen using the appropriate combination of screws, washers, and spacers as shown in step 2-1 or 2-2.

NOTE: Top and bottom holes must always be used.

Verify that all holes are properly aligned, and then tighten screws using allen wrench (L).

B

CENTER BRACKETS

VERTICALLY

ON BACK OF

SCREEN

NOTE: "X" dimensions should be equal.

NOTE: For flat back screens proceed to step 2-1. For bump-out or recessed back screen skip to step 2-2.

6 of 34

ISSUED: 05-29-08 SHEET #: 202-9283-6 12-01-09

Image 6
Contents Models SUF660P Screen Compatability RequirementsTools Needed for Assembly Table of ContentsParts List Installation to Wood Stud Wall Installation to Solid Concrete or Cinder Block Installing Adapter Brackets For Flat Back Screen Mounting and Removing Flat Panel Screen DetailModelo SUF660P Requisitos para la compatibilidad de las pantallasEspañol Herramientas necesarias para el ensamblajeTabla de centenido 10 deCantidad 11 deInstalación en una pared con montantes de madera 12 de13 de Incorrecto CorrectoInstalación de los soportes adaptadores 14 de15 de Instalación y desinstalación de la pantalla plana 16 deModèle SUF660P Exigences de compatibilité avec lécranFrançais Outils nécessaires au montageTable des matières 18 surListe des pièces Français 19 surInstallation sur des murs à en bois 20 surInstallation sur du béton plein/block de béton 21 surInstallation des supports adaptateurs 22 surPour les écrans à dos plat 23 surMontage et demontage dun écran plat 24 surModelle SUF660P Anforderungen an Bildschirmkompatibilät Deutsch Für den Zusammenbau erforderliche WerkzeugeInhaltsverzeichnis 26 vanTeileliste Bescreibung Anz Teile NrInstallation zu verdoppeln Holzständerreihe Installation zu massivbeton oder porenbetonstein Achtung Anbringung von AdapterhalterungenBildschirme mit flacher Rückseite Anbringung und Abnahme des Flachbildschirms DetailansichtLimited FIVE-YEAR Warranty Garantie DE Cinq ANS