Peerless Industries SUF660P manual For Flat Back Screen

For Flat Back Screen

2-1	Begin with the shortest length screw, hand thread through washer and adapter bracket into screen as shown below.
	Screw must make at least three full turns into the mounting hole and fit snug into place. Do not over tighten. If screw

cannot make three full turns into the screen, select a longer length screw from the baffled fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

NOTE: Spacers may not be used, depending upon the type of screen.

NOTE: If screen manufacturer's requirements state that more than 0.33" of ventilation is required, spacers may be used to add an additional 0.5" of space between the wall and the screen as shown right.

SCREEN SCREEN

WASHER (I)

SCREW

ADAPTER

BRACKET (B)

SPACER (J)WASHER (I)

SCREW

ADAPTER

BRACKET (B)

If you have any questions, please call Peerless customer care at 1-800-865-2112.

For Bump-out or Recessed Back Screen
2-2	Begin with longer length screw, hand thread through washer, adapter bracket and spacer in that order into screen
	as shown below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not

over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffled fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

SCREEN

SPACER (J)WASHER (I)

SCREW

ADAPTER

BRACKET (B)

If you have any questions, please call Peerless customer care at 1-800-865-2112.

7 of 34 ISSUED: 05-29-08 SHEET #: 202-9283-6 12-01-09