NOTE: Read entire instruction sheet before you start installation and assembly.
WARNING
•Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US customers please call Peerless customer care at
•This product should only be installed by someone of good mechanical aptitude, has experience with basic building construction, and fully understands these instructions.
•Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard- ware and components.
•Never exceed the Maximum Load Capacity. See page one.
•If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an "edge to edge" stud fi nder is highly recommended.
•Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
•Tighten screws fi rmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding power.
•This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.
•This product was designed to be installed on the following wall construction only;
WALL CONSTRUCTION | HARDWARE REQUIRED | |
• | Wood Stud | Included |
• | Wood Beam | Included |
• | Solid Concrete | Included |
• | Cinder Block | Included |
• | Metal Stud | Do not attach except with Peerless Metal Stud Accessory Kit - ACC415; |
|
| (not UL evaluated) |
• | Brick | Contact Qualifi ed Professional (not UL evaluated) |
• | Other or unsure? | Contact Qualifi ed Professional |
Tools Needed for Assembly
•stud fi nder ("edge to edge" stud fi nder is recommended)
•phillips screwdriver
•drill
•5/16" (8 mm) bit for concrete and cinder block wall
•5/32" (4 mm) bit for wood stud wall
•level
Table of Contents
Parts List | 3 |
Installation to Double Wood Stud Wall | 4 |
Installation to Solid Concrete or Cinder Block | 5 |
Installing Adapter Brackets | 6 |
Installing Flat Panel Screen to Wall Plate | 8 |
2 of 34 | ISSUED: |