Peerless Industries PWS211, PF640 manual For Flat Back Screen

For Flat Back Screen

2-1	Begin with the shortest length screw, hand thread through washer and adapter bracket into screen as shown
	below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not over tighten.

If screw cannot make three full turns into the screen, select a longer length screw from the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

NOTE: Spacers may not be used, depending upon the type of screen.

fig. 2.1

SCREEN

WASHER

SCREW

ADAPTER

BRACKET (BB)

If you have any questions, please call Peerless customer care at 1-800-865-2112.

For Bump-out or Recessed Back Screen

2-2	Begin with longer length screw, hand thread through washer, adapter bracket and spacer in that order into screen
	as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not

over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

SCREEN

SPACER

fig. 2.2

WASHER

SCREW

ADAPTER

BRACKET (BB)

If you have any questions, please call Peerless customer care at 1-800-865-2112.

7 of 34 ISSUED: 11-09-07 SHEET #: 202-9251-4 04-12-10