Sima Products SUR-35 user manual Table of Contents

	Troubleshooting		SUR-35 User Manual
		Solution
	Problem
	You see “ERROR”	Make sure you hold the other remote’s
	display on the LCD	button down for about 2 seconds.
		Make sure you did not program more than
	during the learning
		one remote for a given device.
	procedure.
		Make sure the two remotes are not too
		close or too far apart and are aiming
		directly at each other - keep apart
		between 2~4 inches (5~10cm ).
		The button that you pressed has not been
		taught.
	You see “ERROR”	Teach the button using the learning
	display during	procedure. (page 31)
	operation.	If unit locks up, remove one battery - wait
		ten seconds - and re-install battery
	Your VCR will not	As a safety feature on SUR-35, you
	record.	must press the REC key for 3 seconds.
	Problems changing	If your original remote requires the
	channels.	ENTER key to be pressed after a channel
		is selected, press the ENTER key to
		select the channel.
	Won’t go into SETUP	Batteries are low. Replace batteries.
	mode
	Backlight doesn’t	Backlight disabled. See Backlight
	work	Time Period (pg. 53)
	C
Page

SUR-35 User Manual Table of Contents

Table of Contents

Chapter 1 - Introducing the SUR-35	................ 5
SUR-35 Features	5
Unpacking the SUR-35	6
Identifying Components	6
Chapter 2 - Getting Started	7
Features Overview	7
Features (cont.)	8
Low Battery Indicator	9
Installing Batteries	9
Touch Screen	10
Turning the Touch Screen On	10
Touch Screen Buttons	11
Rubber Buttons	11
Menus	12
Setup Menu	13
Delete Menu	14
Macro Menu	15
Chapter 3 – Setting Up the SUR-35	16
Date and Clock	16
Choosing a Device	17
Creating a New Device	18
Labeling a Device	19
Changing the Touch Screen Layout	19
Programming Infrared Codes	22
Using Pre-programmed Manufacturer Codes	23
Using the Learning Function	25
Learning from Another Remote Control	27
	Page

58 iii