Sima Products SUR-35 user manual Features, Backlight Time Period

Features		SUR-35 User Manual
2	Features (cont.)

•LCD Indicators: LCD stands for Liquid Crystal Display and these indicators at the top of the display give you feedback and information. You can look here to see if the beep is turned on, if the battery has low power, if the infrared signal was sent OK or if there was an ERROR, and also to see which page of Touch Screen buttons you are looking at.

•UART Port: This port allows you to connect the SUR-35 to a personal computer. See Appendix B – Accessories for more information.

•Backlight / Sleep Key: If pressed quickly, this key will activate the Touch Screen backlight. If held down for three seconds you will enter the Sleep menu.

•Page / Date Key: This key allows you to switch between Page 1 and Page 2 of Touch Screen Buttons.

•Learning Eye: This is an infrared sensor used to detect other remote controls infrared signals. Aim your existing remote control here when using the SUR-35’s Learning Function.

•Device Buttons: These 8 buttons allow you to switch between different devices. Each button may have more than one device. (For example, the TV button may have TV1 and TV2 for different TVs in your house.) Repeatedly press the same device button to cycle through all the device names . The SUR-35 has the capability to operate a total of 16 devices maximum.

•Touch Screen: The touch screen acts as a “virtual” keyboard on the SUR-35. The display is normally blank when the remote is not in use and can be activated by simply touching it.

•Function Keys: These keys allow you to enter the SETUP, DELETE, and MACRO menus. To enter any function menu, press and hold the appropriate function key for three seconds.

Ch.

2

Page

SUR-35 User Manual Backlight

Backlight Time Period

This setting specifies how long the SUR-35 will keep the backlight on after the user presses the BACKLIGHT button. This setting can be changed from 1 second to 60 seconds by using the LITE selection of the SETUP Menu:

To enter the SETUP menu press SETUP button for three seconds. Complete the password protection sequence 2...4...6...8.... Use the arrow

buttons to select the LITE menu.

1.Use the arrow keys to set the backlight period. Set the time period from 02 to 60 seconds. You can disable the backlight by setting the time to 0. Press OK when finished and EXIT to return to the SETUP Menu.

Ch.

7

Page

8 53