Sima Products SUR-35 user manual Appendix C Troubleshooting, Creating and Using Macros

Table of Contents	SUR-35 User Manual
Collecting Unrecognized Infrared Codes		31
Deleting a Specific Key		32
Deleting a Device		33
Chapter 4 – Controlling Devices		35
Changing Touch Screen Pages		35
Selecting a Device to Control	.....................................	35
Controlling the Device		36
Chapter 5 – Creating and Using Macros		37
Introduction to Macros		37
Creating a Macro Sequence		37
Using Macros		42
Deleting a Macro		42
Chapter 6 – Other Features		43
Using Timers		43
Setting Up a New Timer		44
Using Quick Channel Lists		46
Setting up Channel Lists		46
Deleting Channels from a Quick Channel List		48
Using Quick Channel Lists		49
Transmitting System Setup		49
Using Sleep Mode		50
Displaying Version Number		51
Chapter 7 – Changing SUR-35 Parameters ...		52
Power Down Time Period		52
Backlight Time Period		53
Resetting to Factory Defaults		54
Beep Toggling		54
Appendix A – Specifications		55
Appendix B – Accessories		56
Appendix C – Troubleshooting		57
Warranty		60
Page

SUR-35 User Manual Troubleshooting

Appendix C – Troubleshooting
Problem	Solution
LCD does not	Batteries may be dead. Replace the batteries
show anything	with new Alkaline Batteries.
when you touch it	Check that the batteries are properly installed.
or press the
rubber buttons.	Make sure switch in battery compartment is set
	to “NORM”
The SUR-35	Make sure that the desired device screen on
doesn’t operate a	the SUR-35 LCD panel has been selected.
device.
	Move closer to the device. The maximum
	operating distance is approximately 30 feet.
	Ensure that you are aiming the SUR-35 directly
	at the device and that there are no obstructions
	between the SUR-35 and the device.
	Ensure programming with the learning function
	or using the manufacturer codes has been
	properly done.
	If “error” message, try re-teaching button.
	Make sure that you have correctly “taught” your
	device’s remote control to the SUR-35.
You cannot	Delete the device data from the SUR-35 and
operate a device	carry out the learning function again.
even after
teaching the	Make sure you did not program more
device using the	than one remote for a given device.
learning function.
“Full” message	Device button capacity is full. Delete	C
appears.	a device.
		Page

iv 57