Outdoor Wireless Motion Sensor

Estimated Installation Time: 30 minutes

Items needed for installation (not included):

•	Phillips and flathead screwdrivers
•	Pliers	•	Wire strippers/cutters
•	Safety glasses	•	Light bulbs
•	Silicon caulk	•	Black tape

Installing Outdoor Motion Sensor

1.	Installsensormountingbracketwheremotiondetectionisdesired.
	Attach sensor mounting bracket to a sturdy object (i.e. tree, post,
	house, etc.) using two screws provided. Make sure unit has an
	unobstructed view. Note: Attach mounting bracket vertically if
	connecting to a curved surface such as a post.
2.	Install motion sensor to mounting bracket. Using a Philips-head
	screwdriver, loosen the clamp screw on the mounting bracket.

Features:

Outdoor Wireless

Motion Sensor

•No wiring required.

•Up to 70 feet sensing range, 180° Cover- age.

•Adjustable sensitivity.

•Day/Night or Night only operation.

•Test mode.

•Uses 2 AA batteries.

•Wall or eave mount.

•Controls receivers up to 100 feet away.

Insert swivel ball mount on sensor into mounting bracket socket		ENGLISH
(Note: You should hear a snap). Aim sensor toward area where
detection is desired. Tighten clamp screw.
IMPORTANT: The sensor must be mounted with the bottom cover
facing down in order to maintain water tightness.
	Mounting Bracket
Mounting
Bracket Socket	Mounting Screw
	Nut

Select Night or 24 Hour Mode

These sensors are able to detect motion day and night or night only. To set the detection mode, remove battery compartment cover by sliding the cover down. Remove batteries if necessary. Slide the DETECT switch to either the DAY/NIGHT or NIGHT ONLY position. Replace battery compartment cover by reversing the above instructions.

Installing Batteries

•Before mounting outdoor motion sensor, remove battery compart- ment cover by sliding the cover down.

•For indoor motion sensor, install batteries after sensor is in- stalled.

Install 2 AA batteries according to polarity markings inside the battery compartment. Replace battery compartment cover by reversing the above instructions.

Detect

	DAY	NIGHT	Control
	NIGHT	ONLY	Control
1 2 3 4	DETECT
CODES

Outdoor Motion Sensor

(Rear View)

Battery Compartment

Clamp

Screw

Swivel Ball Mount

Sensor

Installing Motion Sensor

Check Operation and Adjustment

Note: When first turned on or when switching modes wait 30 seconds.

Locate the RANGE control and ON-TIME control on the motion sensor:

•Indoor Motion Sensor - The RANGE control and ON-TIME control are located inside the battery compartment on the front of the sensor. To set the RANGE or ON-TIME control, remove battery compartment cover by sliding the cover down.

•OutdoorMotionSensor -TheRANGEcontrolandON-TIMEcontrol are located on the bottom of the sensor. Using your fingernails or a small, flat-head screwdriver, gently pry the cover until it opens.

1.Check Operation. Set the ON-TIME control to TEST mode. Walk in frontofsensorunit.TheLEDindicatorlightshouldflashwhenmotion is detected (see illustration, page 8, for location of LED light).

2.Adjust Sensor. Turn the RANGE control to the mid position and ON-TIME control to the TEST position. Walk through coverage area noting where you are when the LED begins to flash. Loosen the clamp screw and move the sensor to change the coverage area. Tighten clamp screw when finished. Do not overtighten clamp screw.

Heath Zenith UT6028-WH, UT-6028-BZ Outdoor Wireless Motion Sensor, Select Night or 24 Hour Mode