3 Installation
This section provides instructions for the installation of the Nero 3D projector. Important: Installation procedures should be performed by a qualified AV system spe- cialist.
Location
When installing the Nero 3D projector, take the following considerations into account.
Installation Type
Select the installation type that best suits your needs:
•front or rear projection
•floor or ceiling mount
Lens Type
Choose the desired distance from the screen and select the lens type (T1, T2 or T3) that determines the desired screen size.
Cooling
Make sure that the planned location for the projector has adequate ventilation. Check that room temperature is below 35° C and that the projector is away from heating vents. Ensure a minimum 0.25 m (10 in.) clearance on the left, right and rear sides of the projector.
Power Outlets
Verify that the powers outlets are grounded and preferably shielded from power surges and fluctuations. A UPS is optional. Nero 3D power supply operates on any nominal line voltage between
Cables
Check planned cable lengths for video and control cables and make sure these lengths do not exceed specifications.
Ambient Light
Avoid or minimize light sources directed at the screen to preserve the quality of the projected image.
Mounting
The projector can be Floor mounted (upright) or Ceiling mounted (inverted). Choose the method that best suits your installation.
Important: The projection lens is not centered to the chassis (it is
Floor Mounting
Position the projector on a secure and flat surface (such as a table or a shelf). Adjust the three feet at the bottom of the projector until the projector is level on all sides.
3 Installation | Nero 3D | 13 |
| User Guide |
|
|
|
|