Sim2 Multimedia NERO 3D-1, NERO 3D-2 3D Input Format, 3D Left/Right, Supported 3D Video Formats

•2D display mode for normal 2D material. 3D Input Format adjustment is un- available. PureMotion adjustment is available.

3D Input Format

The Nero 3D checks AVI infoframe data and input signal resolution in order to determ- ine the appropriate 3D format. When automatic detection of 3D format is not pos- sible, choose one of the following options:

•(S-S) Side by Side Left and right halves of the image are separated, rescaled and displayed. This mode should be applied to 3D images composed of two stereoscopic images compressed to half of their original horizontal resolution and sent simultaneously.

•(T-B) Top and Bottom Top and bottom halves of the image are separated, res- caled and displayed. This mode should be applied to 3D images composed of two stereoscopic images compressed to half of their original vertical resolu- tion and sent simultaneously.

•(F-S) Frame Sequential This mode should be applied to 3D images that consist of a sequence of alternating frames wherein each successive frame carries the image meant for one or the other eye.

Note: You may need to change the order in which left and right frames are displayed. See “3D Left/Right” below.

3D Left/Right

Use this setting if the 3D effect has an uncomfortable look about it. This setting will change the perception of depth. It is important that the image destined for the left/right eye reaches the correct eye. Sometimes the easiest way to check is to pause the program content to check. For the effect to change you must press Esc to exit from the OSD.

•Normal Left and right frames are displayed in the native sequence.

•Swapped Left and right frames are swapped. Use this setting if image does not give the correct sense of depth.

Supported 3D Video Formats

Compatible 3D formats are listed in Table 4.1.

4 Operation	Nero 3D	21
	User Guide