3M 2573 Modifying Marker Data to be Written, Press Menu/OK 5Toggle to Main Menu + Write Mode SK1

Step 8. After writing to the 3M™ iD Marker is completed, the following screen will be displayed. The following messages may appear in the writing process.

−− Message 1. If the overwrite option was set to "No" And there was data present on the target market then the following screen will be displayed;

−− Message 2. When writing to a passive marker or the wrong frequency then the following will be displayed.

−− Message 3. This screen indicates that X-Type marker option was incorrectly set to "Yes" or "No". Verify the serial number that is displayed on the marker ends with an “X” to select "Yes" for X-Type, else select "No".

Note: Once the marker data has been locked, the information contained on the marker is PERMANENT. Choosing to permanently lock the marker data is irreversible. Once the data is locked it can not be overwritten. Assure that the data that is being written is correct before proceeding.

A. Modifying Marker Data to be Written

To alter the information to be written into the marker

Press Menu/OK [5:Toggle to MAIN MENU] + Write Mode [SK:1].

Step 1. Select a template from the list on the display to be written into the marker by pressing the up/down arrows [SK] to highlight the preferred template. ‘Last Written/Read’ is the most recent data that was written to/read from a marker by the receiver.

52 78-9000-0192-2 Rev C