Kathrein UFS 922 sw, UFS 922 si manual Connection and setup

Connection and setup

The following display appears:

LNB type (settings):

If your reception system does not have a Universal LNB,

use the  buttons to select the LNB types that are used in your reception system. You can choose from the following LNB types:

-Universal

-Simple or

-User-defined

LNB frequency (MHz):

You only need to specify this data if your LNB type is not “Universal LNB”. The data required differ for the settings “Simple” and “User-defined”. Refer to the documentation supplied for your LNB.

-	Selection “Simple” LNB:	Use the numeric keypad to enter the LNB frequency
-	Selection “User-defined”:	Press the button to input the required low, high and limit frequencies as necessary.
		The input is performed using the numeric keypad

DiSEqC™ Input:

Select the “DiSEqC™ Input” field. Here, you set the “Position” for the satellite displayed on the screen, to match the configuration of your reception system. You can choose between: “1/1”, “1/2” and “2/2” depending on whether you selected one or two satellites under “Satellite selection”.

Test-Transponder:

Select the “Test-Transponder” field. Here you can select a transponder for checking whether your settings are correct using the signal strength bar and signal quality bar.

If a connection to the one cable system cannot be established, check your settings (frequency and transmission channel) and if necessary call for expert help.

When you have completed all settings for this satellite, press the (green) button. The receiver will now save these values for this satellite and skips automatically to the setting for the next satellite.

If you have selected more than one satellite for tuner 1, the receiver will automatically skip to the settings for the second satellite. Now make the settings for the second satellite in the same way as described for the first satellite.

Once you have completed the settings for the satellites assigned, the receiver will automatically display the screen for the channel search. Continue the first installation with the “Channel search” chapter.

35