FIRST INSTALLATION: Simple LNB
Satellite and position
Use the buttons to select the desired satellite whose signal is to be received by the tuner.
When you have selected your
desired satellite, use the buttons to switch to the selection of the “LNB Type”.
LNB settings
Use the buttons here to select the LNB type used in your system. The choice is between “Universal” and “user- defined”.
Universal:
No further input is required, since all necessary frequency ranges are covered by a universal LNB.
If you choose not to use a universal LNB, you must here set the frequency ranges for which your LNB was configured.
Use the buttons to select the frequency range to be changed (low / high frequency).
Use the buttons or the keypad to set the exact frequency for which your LNB was configured.
LNB voltage
Use the buttons to select whether your LNB is supplied with power from the receiver (“On”) or whether it has its own power supply (“Off”).
Test transponder
To check whether the settings that you have made are correct, use the buttons to move to the “Test
transponder” field. Use the buttons to select the required transponder from the various ones listed. If your settings are correct, you will see at the top right of the screen the live signal of a channel from the currently selected transponder.
If you are not receiving a signal, check your settings again and if necessary call for expert help.
17