Petsafe PPA11-10709, PPA11-10711 Installing Your SmartDoor, Determine Pet Door Location, Step

AUTOMATIC MODE – Allows entry and exit for a pet wearing a programmed SmartKey™. To set: hold the MODE-RESET button until the yellow light illuminates and release when selected. Five SmartKeys™ can be programmed to one SmartDoor™ for selective entry and exit during AUTOMATIC MODE.

NOTE: If at any time the red light remains illuminated, replace with a set of fresh batteries. If that does not reset the red light, please call our Customer Care Center for additional help.

If any part of step C was unsuccessful, please call our Customer Care Center for additional help.

D. Check SmartDoor™ Location Before Installation

DO NOT REMOVE SENSITIVITY STICKER BEFORE INSTALLING THE SMARTDOOR™.

Prior to installation, it is recommended to check that the SmartDoor™ will operate properly in the intended location or application to guard against possible severe radio-frequency interference. Household appliances and common electronic products should be located at least two feet (60 cm) away from the SmartDoor™’s location. Radio-frequency interference detected from other household appliances or common electronic products will negatively affect the ability of the SmartDoor™ to receive a SmartKey™ signal. Typical appliances and products to consider are laptop computers, wireless telephones, microwaves, televisions, garage door openers, hand-held electronic devices (such as cell phones, game stations and remote controls).

The sticker placed over the sensitivity knob should not be removed until after installation, as the factory default sensitivity setting is positioned at the optimal level for most installations.

It is recommended to install SmartDoor™ in a location where direct wind is not a factor. Operating Temperature Range: -5˚ F to 180˚ F (-20.5˚ C to 82˚ C). Operating Humidity Range: 0 to 99.9%.

•To check if SmartDoor™’s radio-frequency technology will operate properly in desired location and application, place SmartDoor™ directly in front of and against the door or application in the upright position. After performing steps A-C, now set the SmartDoor™ in AUTOMATIC mode and hold the SmartKey™ directly in front of the SmartDoor™. The SmartDoor™ flap should unlock in about three seconds. Remember, the SmartKey™ included in the kit is already programmed to the SmartDoor™.

NOTE: If there are existing SmartKeys™ in the household, remove all (RFA-67) batteries while performing step D except the SmartKey™ included with the SmartDoor™.

If the SmartDoor™ does not unlock, move the SmartDoor™ to another location and follow steps A-D once more. If the SmartDoor™’s location test above was unsuccessful, please call our Customer Care Center for additional help.

When steps A-D are completed and all are successful, your SmartDoor™ is ready for installation.

INSTALL
Installing Your SmartDoor™
Step	Determine Pet Door Location
1	1A		1A Measure and mark your pet’s shoulder
		1B	height on the door.
			1B Determine location for the pet door. Draw
			a vertical center line through the shoulder
			height line using a level.
			NOTICE
			If homeowner’s door or other application is
			not level, the pet door must be marked level to
			swing properly.

www.petsafe.net 7