Petsafe PPA11-10709, PPA11-10711 manual Install Pet Door, Step Insert Screws, Step Train Your Pet

Step

4

Install Pet Door

Before putting away the jigsaw, place the interior frame (frame with the flap) inside the cut out and check the fit. Then, place the exterior frame into the underside of the door to check the fit. If frames do not fit inside the opening, you may need to recut to square opening before proceeding with installation.

4

4 Re-hang door and place interior frame with

flap inside cut-out of interior door. Place exterior frame on exterior of door and press firmly against interior frame and exterior frame with both hands. Continue to press while moving hands from bottom to top of frames until alignment tabs connect and both frames are firmly in place.

Helpful Tip: Use painters’ tape across SmartDoor™’s interior frame and door to keep in place while positioning the exterior frame.

Step Insert Screws

5 5

5 Thread mounting screws through interior frame and align with exterior frame. Tighten with screwdriver. DO NOT OVERTIGHTEN.

Helpful Tip: If using an electric screwdriver, set on low torque.

NOTE: Small SmartDoor™ has four screw placement holes and Large SmartDoor™ has eight screw placement holes.

Step Train Your Pet

6 6

6 Tape the flap open to help your pet become familiar with the pet door opening. When your pet is more comfortable let the flap down and operate the SmartDoor™ in UNLOCKED Mode encouraging your pet to push through the flap. Once your pet is comfortable entering and exiting through the closed flap, set SmartDoor™ to AUTOMATIC Mode and operate with your pet’s programmed SmartKey™. Walk your pet up to the SmartDoor™ until the SmartKey™ is detected and flap unlocks. Repeat training your pet to walk up to SmartDoor™ and push open flap to the other side.

Helpful Tip: Try treats to encourage your pet to push through the SmartDoor™ flap.

www.petsafe.net 9