A. Place Batteries in the SmartDoor™
1. With a Phillips screwdriver, remove the two Battery Compartment Cover screws.
2. Remove the Battery Compartment Cover.
3. Refer to the inside of the Battery Compartment Cover for the proper orientation of the four
4. Replace the Battery Compartment Cover and re- install the two screws.
5. When the batteries are placed in the Electronic SmartDoor™ the red light will illuminate for two seconds and the flap will move into the locked position, unless the flap is already in the locked position.
NOTE: The door must be in the upright position for the flap to center properly and operate correctly.
B. Place Battery in the SmartKey™
1.Place the PetSafe®
2. Using a coin, rotate
NOTE: The SmartKey™ has a red light that will flash when the PetSafe®
C. Check Operational Modes Before Installation
Operational Indicators
Electronic SmartDoor™ |
|
|
|
|
|
A. Sensitivity Knob |
| A |
|
|
|
B. Locked or Low |
|
|
|
|
|
Battery Red Indicator |
|
|
|
|
|
C. Unlocked or Learn |
|
|
|
|
|
Mode Green Indicator |
|
|
|
|
|
D. Automatic or Error |
|
|
|
|
|
Mode Yellow Indicator |
|
|
|
|
|
E. |
|
|
|
|
|
Selection Button |
|
|
|
|
|
F. Learn Mode Button | B | C | D | E | F |
•To check if operational settings are working properly, hold down the
Operational Modes
LOCKED MODE – Does not allow entry or exit for any pet. The SmartDoor™ ships from the factory in LOCKED MODE and when batteries are placed in the SmartDoor™, it will enter LOCKED MODE. To set: hold the
UNLOCKED MODE – Allows entry and exit for all pets. To set: hold the
6 |