Petsafe PPA11-10709 Troubleshooting, Operate, C. Programming a New SmartKey, Illuminating Color

C. Programming a New SmartKey™

To reduce error while programming, remove the RFA-67 battery from all programmed SmartKeys™ except the one you are programming. Press and hold the LEARN button until the green light illuminates and begins to flash, now release the button. Bring the SmartKey™ directly below the green light and the light will stop flashing and illuminate for two seconds. Now your new SmartKey™ has been programmed and added to memory. Up to five different SmartKeys™ can be added, one at a time.

D. Attach the SmartKey™ to the Pet’s Collar

A split key ring has been provided to attach to your pet’s collar and should hang under the pet’s neck.

The SmartDoor™ includes (one) SmartKey™ which comes pre-programmed and ready to use.

OPERATE

Operating Your SmartDoor™

LOCKED MODE – Does not allow entry or exit for any pet. The SmartDoor™ ships from the factory in LOCKED MODE and when batteries are placed in the SmartDoor™, it will enter LOCKED MODE. To set: hold the MODE-RESET button until the red light illuminates and release when selected.

UNLOCKED MODE – Allows entry and exit for all pets. To set: hold the MODE-RESET button until the green light illuminates and release when selected.

AUTOMATIC MODE – Allows entry and exit for a pet wearing a programmed SmartKey™; up to five SmartKeys™ can be programmed into one SmartDoor™ for selective entry and exit during automatic mode. To set: hold the MODE-RESET button until the yellow light illuminates and release when selected.

NOTE: If at any time the red light remains illuminated, replace with a set of fresh batteries. If that does not reset the red light, please call our Customer Care Center for additional help.

Illuminating Color	Condition	Pet Door Status
	Solid only for two seconds after	LOCKED Mode
RED	selecting LOCKED Mode
	Flashing	Low battery alert
	Constant solid	Internal failure has occurred
	Solid only for two seconds after	UNLOCKED Mode
GREEN	selecting UNLOCKED Mode
	Flashing	Learn Mode
	Solid only for two seconds after	AUTOMATIC Mode
YELLOW	selecting AUTOMATIC Mode
	Flashing	Error alert
RED, GREEN AND YELLOW	Flashing at the same time	Sensitivity Test Mode

Troubleshooting

SmartDoor™ does not respond to the presence of the SmartKey™ when my pet is directly in front of the SmartDoor™ within three seconds

•Check that the SmartDoor™ is in AUTOMATIC Mode.

•Check that the SmartKey™ has been programmed to the SmartDoor™.

•Check sensitivity level has been properly set, see page 10.

•Check that the RFA-67 battery in the SmartKey™ is screwed in tightly.

•Check that the batteries in the SmartDoor™ are fresh.

•If the condition persists, check that there are no radio-frequency transmitting devices or electronic devices that radiate electrical energy, which may interfere with the operation of the SmartDoor™.

www.petsafe.net 11