MotoSAT Using the Nomad 2 Universal Controller, First Time Installation, Labeled To Nomad

Page 4

Using the NOMAD 2 Universal Controller

●Dish Pro 500 (300,500,800) Series Receiver(s) are a required component when using the Model MD500.

First Time Installation:

1- Plug in all necessary cable connections to the back of the NOMAD 2 (see diagram on pg. 8). Note: Plugging the receiver and NOMAD 2 controller into an independent power strip is recommended.

2- Connect coax from NOMAD 2 to Mount.

IMPORTANT!!

(Labeled “To Nomad 2)

3- Set the satellite mode to which service you are using by using the Quick Guide for DirecTV, Dish Network, Etc. You will also need to know whether or not your unit is a non-skewableunit [Executive, Freedom], or a skewable unit [MD500, MHDTV]. To get into the satellite mode selector, have the Nomad power off, hold both the Find’ and ‘Stow’ buttons down and hit the Power Button, continue to hold down the Find and Stow button for an additional 5 seconds after power is on. Let go at this point and the front display lights will show the current satellite mode of the unit. Use the ‘Find’ and ‘Stow’ buttons to cycle through the light patterns until the desired configuration is shown. Turn the ‘Power’ off to store the programmed settings. [See page 14 Satellite Mode Guide and page 17 Quick

Guide for configurations and more detailed instructions]

3

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Page Nomad 2 Universal Controller User Instructions Manual Nomad 2 Universal Controller Specifications Nomad 2 Universal Controller Bill of MaterialsUsing the Nomad 2 Universal Controller First Time InstallationGuide for configurations and more detailed instructions Labeled To NomadNomad 2 Universal Controller Front Panel Buttons Dish Services and their Assigned SatellitesFind Find Satellite LED’S If the Mount Type is Skewable Models MD500 and Mhdtv If the Mount Type is a NON-SKEWABLE Freedom using the NomadIf the Mount Type is NON-SKEWABLE Executive One LNB Wiring to 9 Pin Control Connector Nomad 2 Universal Controller Rear PanelNomad 2 Visual Setup Diagram Error Codes are Flashing LED Lights AT 1 Second Intervals Find and Stow Flashing Invalid ModePeak, Find and Stow Flashing Limit Error Elevation DVB, Peak, Find and Stow Flashing Signal lost no LNB PowerPage If you are able to go onto the roof NON-SKEWABLE Dome or Open Faced mountsIf you are unable to go onto the roof Rain Fade on Dome Systems Subject Rain fade on Domed Covered SystemsWiring Table Technical Support Department atShow Modes Page Page To Test Dish To ProgramTo Locate Satellite Step
Top Page Image Contents