MotoSAT manual Nomad 2 Visual Setup Diagram

Page 9

Serial Port: Used to provide software upgrades.

From Dish: Coax connection from the dish to the NOMAD 2 Universal Controller.

To Satellite “IN” on Receiver: Coax connection used to connect the NOMAD 2 Universal Controller to the satellite/LNB connection on the satellite receiver.

NOMAD 2 VISUAL SETUP DIAGRAM

Satellite Mode Guide: Configuration

TROUBLESHOOTING

Image 9

Contents Page Nomad 2 Universal Controller User Instructions Manual Nomad 2 Universal Controller Bill of Materials Nomad 2 Universal Controller SpecificationsFirst Time Installation Using the Nomad 2 Universal ControllerGuide for configurations and more detailed instructions Labeled To NomadDish Services and their Assigned Satellites Nomad 2 Universal Controller Front Panel ButtonsFind Find Satellite LED’S If the Mount Type is a NON-SKEWABLE Freedom using the Nomad If the Mount Type is Skewable Models MD500 and MhdtvIf the Mount Type is NON-SKEWABLE Executive One LNB Nomad 2 Universal Controller Rear Panel Wiring to 9 Pin Control ConnectorNomad 2 Visual Setup Diagram Find and Stow Flashing Invalid Mode Error Codes are Flashing LED Lights AT 1 Second IntervalsPeak, Find and Stow Flashing Limit Error Elevation DVB, Peak, Find and Stow Flashing Signal lost no LNB PowerPage NON-SKEWABLE Dome or Open Faced mounts If you are able to go onto the roofIf you are unable to go onto the roof Subject Rain fade on Domed Covered Systems Rain Fade on Dome SystemsTechnical Support Department at Wiring TableShow Modes Page Page To Program To Test DishTo Locate Satellite Step