MotoSAT Nomad 2 manual Wiring Table, Technical Support Department at

WIRING TABLE

Open Face TV Mounts

The Control Cable, 9 conductors, colored coded, 22Awg stranded that connects to the mount with a twist lock connector is configured in the following manner:

Color Code	Pin Designation	Mount	Counts
		Destination	per Degree
Black	1	Motor, Azimuth Positive
*Brown	2	Motor, Azimuth/Skew
		Negative
*Red	3	Motor, Elevation/Skew
		Positive
Orange	4	Motor, Elevation
		Negative
Yellow	5	Sensor, Count Azimuth	3.408
Green	6	Sensor, Ground
		Azimuth/Elevation
Blue	7	Sensor Count Elevation	5.034
White	8	Power, Mount LED
**Purple	9	Sensor, Count Skew	8.500

*The Brown and Red wire perform a dual function when used on a Skewable (MD500/MHDTV) mount. They control the Skew motors when directed by the Nomad 2 Controller. Applying 12 volt power directly to these wires will skew the dish.

**The Purple cable is for use on skewable dishes but it WILL NOT effect the operations of a non-skewable dish when it is connected (or not connected).

The Mount is coil wrapped inside with the following cables and wire:

2 ea	RG179 Teflon coated coax cables (can do four (4) if required)
1 ea	Control Cable, 9 conductor cable, colored coded, 22Awg stranded. This cable
	is molded with a twist lock connector on one end and manually terminated
	at the other with a 9 pin connector.

2 or 4 ea RG179 coax cables terminate at the LNB to provide availability of cabling for multiple receivers.

1 ea Black and White 22Awg stranded wires carry the positive (white) voltage and ground (black) to the LED which is used to illuminate the dish face.

For any questions or comments please contact our

Technical Support Department at 1-800-247-7486.

13