MotoSAT Nomad 2 manual NON-SKEWABLE Dome or Open Faced mounts, If you are able to go onto the roof

Page 12

Special Notes

Stowing the dish when all else fails.

If you are able to go onto the roof -

1.Unplug the “Green” 9 pin connector from the back of the NOMAD 2.

2.Go to the roof where you can apply a slight amount of force to move the dish into an acceptable position for traveling.

3.Call Tech Support when you get to a location that you can perform trouble shooting.

If you are unable to go onto the roof –

The dish can be manipulated by applying 12 volt DC power to specific wires in the control cable located in the back of the NOMAD 2. The 12 Volts going to your NOMAD 2 controller (3 pin “green” connector) can be used as this source.

1.ELEVATION - Orange and Red wires (reversing polarity will change direction.)

2.AZIMUTH - Black and Brown (reversing polarity will change direction.)

If a chain or motor/gearbox assembly is broken, the dish will have to be stowed by hand.

Dish Network receivers

NON-SKEWABLE Dome or Open Faced mounts.

If your satellite receiver is a Dish 500 or Dish Pro and you remove it from your home to your RV, you will need to perform a “Check Switch” while the non-skewable dish is in the STOWED POSITION. Your screen upon completion of the “Check Switch” should have 8 X’s in the check boxes meaning that the “Check Switch” failed. This procedure must be

accomplished before you “FIND” satellite. Failure to do so will result in improper operation of the receiver.

11

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Page Nomad 2 Universal Controller User Instructions Manual Nomad 2 Universal Controller Specifications Nomad 2 Universal Controller Bill of MaterialsUsing the Nomad 2 Universal Controller First Time InstallationGuide for configurations and more detailed instructions Labeled To NomadDish Services and their Assigned Satellites Nomad 2 Universal Controller Front Panel ButtonsFind Find Satellite LED’S If the Mount Type is a NON-SKEWABLE Freedom using the Nomad If the Mount Type is Skewable Models MD500 and MhdtvIf the Mount Type is NON-SKEWABLE Executive One LNB Wiring to 9 Pin Control Connector Nomad 2 Universal Controller Rear Panel Nomad 2 Visual Setup Diagram Error Codes are Flashing LED Lights AT 1 Second Intervals Find and Stow Flashing Invalid ModePeak, Find and Stow Flashing Limit Error Elevation DVB, Peak, Find and Stow Flashing Signal lost no LNB PowerPage NON-SKEWABLE Dome or Open Faced mounts If you are able to go onto the roofIf you are unable to go onto the roof Rain Fade on Dome Systems Subject Rain fade on Domed Covered SystemsWiring Table Technical Support Department atShow Modes Page Page To Program To Test DishTo Locate Satellite Step
Top Page Image Contents