MotoSAT manual Nomad 2 Universal Controller Rear Panel, Wiring to 9 Pin Control Connector

Page 8

NOMAD 2 UNIVERSAL CONTROLLER “REAR” PANEL

To Satellite Receiver

Power ConnectorSatellite In

Control Cable

Maintenance Port

From Dish

Power Supply Interface: Is used to connect the 12 VDC 4 AMP power supply to

provide power to the NOMAD 2 Universal Controller. (Note: Only use the power supply provided by MotoSAT or a power source known to have at least a 4 Amp min.)

P1 P2 P3

+12V -GND Unused

Control Cable Interface: Connects the mount by way of a 9 pin conductor cable to the NOMAD 2 Universal Controller. The cable is color coordinated for exact connection configuration. (See Figure Below)

Wiring to 9 Pin Control Connector

Black-Brown-Red-Orange-Yellow-Green-Blue-White-Purple

(Purple is only used on Skewable Mounts, and not required on Non-Skewable Mounts)

7

Image 8

Contents Page Nomad 2 Universal Controller User Instructions Manual Nomad 2 Universal Controller Specifications Nomad 2 Universal Controller Bill of MaterialsUsing the Nomad 2 Universal Controller First Time InstallationGuide for configurations and more detailed instructions Labeled To Nomad Find Find Satellite Dish Services and their Assigned Satellites Nomad 2 Universal Controller Front Panel Buttons LED’S If the Mount Type is NON-SKEWABLE Executive One LNB If the Mount Type is a NON-SKEWABLE Freedom using the NomadIf the Mount Type is Skewable Models MD500 and Mhdtv Wiring to 9 Pin Control Connector Nomad 2 Universal Controller Rear PanelNomad 2 Visual Setup Diagram Error Codes are Flashing LED Lights AT 1 Second Intervals Find and Stow Flashing Invalid ModePeak, Find and Stow Flashing Limit Error Elevation DVB, Peak, Find and Stow Flashing Signal lost no LNB PowerPage If you are unable to go onto the roof NON-SKEWABLE Dome or Open Faced mountsIf you are able to go onto the roof Rain Fade on Dome Systems Subject Rain fade on Domed Covered SystemsWiring Table Technical Support Department atShow Modes Page Page To Locate Satellite Step To ProgramTo Test Dish