MotoSAT Nomad 2 manual If the Mount Type is Skewable Models MD500 and Mhdtv

Page 7

OPERATION PROCEDURES

TO FIND A SATELLITE

If the Mount Type is SKEWABLE (Models MD500 and MHDTV)

1.Turn ON power.

2.After 10-15 seconds (after Nomad power up sequencing) press the FIND button.

The dish will search out and lock onto the proper programmed satellite.

3.Pressing the FIND button while on satellite will initiate a re-peaking sequence.

If the Mount Type is NON-SKEWABLE (Executive (One LNB))

1.Turn ON power.

2.After 10-15 seconds (after Nomad power up sequencing) press the FIND button.

The dish will search out and lock onto the proper programmed satellite.

3.Pressing the FIND button while on satellite will initiate a ‘FIND NEXT SATELLITE’ routine.

If the Mount Type is a NON-SKEWABLE FREEDOM (using the Nomad 2)

1.Turn ON Power.

2.If ON a Satellite when turning the Power ON, the system will search for the next available satellite in sequence.

3.If NOT ON a Satellite, the system will search for the primary satellite for the service subscribed to.

4.Once the system has located a satellite, the Power will turn OFF.

When Power is turned ON the system will go through steps 1-4 above.

TO STOW THE DISH

1.Press the STOW button and the dish will stow, or return, to the proper travel position.

After the dish has been properly stowed, the power will automatically turn OFF.

6

Image 7

Contents Page Nomad 2 Universal Controller User Instructions Manual Nomad 2 Universal Controller Bill of Materials Nomad 2 Universal Controller Specifications Labeled To Nomad Using the Nomad 2 Universal Controller First Time Installation Guide for configurations and more detailed instructionsNomad 2 Universal Controller Front Panel Buttons Dish Services and their Assigned SatellitesFind Find Satellite LED’S If the Mount Type is Skewable Models MD500 and Mhdtv If the Mount Type is a NON-SKEWABLE Freedom using the NomadIf the Mount Type is NON-SKEWABLE Executive One LNB Nomad 2 Universal Controller Rear Panel Wiring to 9 Pin Control ConnectorNomad 2 Visual Setup Diagram DVB, Peak, Find and Stow Flashing Signal lost no LNB Power Error Codes are Flashing LED Lights AT 1 Second IntervalsFind and Stow Flashing Invalid Mode Peak, Find and Stow Flashing Limit Error ElevationPage If you are able to go onto the roof NON-SKEWABLE Dome or Open Faced mountsIf you are unable to go onto the roof Subject Rain fade on Domed Covered Systems Rain Fade on Dome SystemsTechnical Support Department at Wiring TableShow Modes Page Page To Test Dish To ProgramTo Locate Satellite Step