IBM manual IBM Netfinity EXP300 Type 3531 Hardware Maintenance Manual

2. On the rail marked R, loosen the four screwsÞ Ýand adjust the rail.

3.Hold the rail against the outside of the right rack-mounting flange, and loosely insert the two front M6 hex screws Þ Ý.

4.Extend the rail outside of the rear rack-mounting flange; then, install and tighten two rear M6 hex screws Þ Ý.

5.Tighten the two front screws Þ Ý; then, tighten the four screws Þ Ý.

Repeat step 2 through step 5 to install the rail marked L on the left side of the rack.

6.Loosely insert one M5 screw Þ Ý into each rail.

28IBM Netfinity EXP300 - Type 3531 Hardware Maintenance Manual