Advantech PCM-3780 manual Accessories, Wiring Cables, Wiring Boards

Page 18

1.6 Accessories

Advantech offers a complete set of accessory products to support the PCM-3780 card. These accessories include:

1.6.1Wiring Cables

• PCL-10120

PCL-10120 cable is a 20-pin flat cable for PCM-3780 cards.

•PCL-10150

PCL-10150 cable is a 50-pin flat cable for PCM-3780 cards.

1.6.2 Wiring Boards

The ADAM-3900 series consists of universal screw terminal modules designed for field signal wiring in industrial applications. They can be connected to the analog and digital ports of Advantech products such as the PCI, PCM and PCL series.

•ADAM-3920

ADAM-3920 is a 20-Pin Flat Cable Wiring Terminal.

•ADAM-3950

ADAM-3950 is a 50-Pin Flat Cable Wiring Terminal.

PCM-3780 User Manual

10

Image 18

Contents Ch Counter/Timer with Ch TTL DIO Module PCM-3780Copyright Acknowledgements Two Years Product Warranty CE Notification FCC Class a Technical Support and Assistance Packing List Page Contents Appendix Specifications Introduction Features PCM-3780 Counter Mode Counter ModesPCM-3780 Counter Mode Installation Guide ApplicationsInstallation Flow Chart Device Drivers Software OverviewDevice Drivers on the companion CD-ROM Register-level ProgrammingDevice Drivers Programming Roadmap Programming ToolsTroubleshooting Device Drivers Error Programming with Device Drivers Function LibraryAccessories Wiring CablesWiring Boards Hardware Installation Unpacking Driver Installation Companion CD-ROMDifferent Options for Driver Setup Hardware Installation Installing the ModulePage Pin Assignments & Jumper Settings Signal Connections OverviewSwitch and Jumper Settings Interrupt Level IRQ Setting JP1Base Address Setting SW1 Base Address SettingConnectors Pin Assignment CN3 I/O Port ConnectorCN4 Counter Interface Connector Connector Signal Description Reference Direction DescriptionUsing Advantech 32-bit DLL Driver Using Direct I/OPeriod Measurement Frequency Measurement Frequency MeasurementSpecifications Programmable Counter Digital Input/OutputGeneral Page Block Diagram Appendix B Block Diagram Register Structure & Format Appendix C Register Structure & Format I/O Port Address MapRegister Format Table C.1 Register Offset Address TableCE CE CM1 to CM0 Output Control Counter 0/1 Mode RegisterCM2 Output Enable Control CM6 to CM3 Count Control CM6CM14 Gating Polarity Selection CM7 Count Source EdgeCM13 to CM12 Gate Source Selection CM15 Gate Active Edge or LevelCounter 0/1 Load Register Counter 0/1 Hold RegisterC2 to C0 Command Code Counter 0/1 Command RegisterCounter Command Enable Register CE1 to CE0 Counter Command Enable BitInterrupt Control Register Interrupt Status RegisterPort A/B/C Interrupt Status Register Interrupt Clear RegisterDirection Control Register O Direction Control BitFout Register DV3 to DV0 Fout Divider Divide by 1 to 16 0000 = Divide byFOE Fout Output Enable FS2 to FS0 Fout SourceWaveform of Each Mode Appendix D Waveform of Each Mode Counter Mode DescriptionsTable D.1 PCM-3780 Counter Mode Table D.2 PCM-3780 Counter Mode Mode a Waveforms Software-Triggered Strobe with No Hardware GatingMode B Waveforms Software-Triggered Strobe with Level GatingMode C Waveforms Hardware-Triggered StrobeMode D Waveforms Rate Generator with No Hardware GatingMode E Waveforms Rate Generator with Level GatingMode F Waveforms Non-Retriggerable One-ShotMode G Waveforms Software-Triggered Delayed Pulse One-ShotMode H Waveforms Mode I Waveforms Hardware-Triggered Delayed Pulse StrobeMode J Waveforms Variable Duty Cycle Rate Generator with No Hardware GatingMode K Waveforms Variable Duty Cycle Rate Generator with Level GatingMode L Waveforms Hardware-Triggered Delayed Pulse One-ShotMode O Waveforms Hardware-Triggered Strobe with Edge DisarmMode R Waveforms Non-Retriggerbale One-Shot with Edge DisarmMode U Waveforms Hardware-Triggered Delayed Pulse Strobe with Edge DisarmMode X Waveforms Hardware-Triggered Delayed Pulse One-Shot with Edge Disarm